Abstract:The MAX phase has attracted much attention due to its unique properties combined with the merits of both metal and ceramic, including the low density, high electrical conductivity and good oxidation resistance, which makes it significant for possible applications in various high temperature or other environments. There is a lot of research work on Ti2AlX (X=C, N). However little research about thermodynamic properties at high pressure is carried out. So we study the structural, mechanical and thermodynamic properties of Ti2AlC and Ti2AlN at various pressures and temperatures. The first-principles calculations based on electronic density-functional theory framework are used to investigate the properties at various pressures. The cut-off energy is 350 eV. Converged results are achieved with 10102 special K-point meshes. The self-consistent convergence of total energy is set to be 5.010-6 eV/atom. According to the calculated structural parameters at various pressures, we can find that the ratios V/V0 (V0 denotes the system volume at 0 GPa) of Ti2AlX are reduced by 20.59% and 18.93%, respectively, so the compressibility of the system is strong. As the internal pressure increases, the curves of V/V0 become gentle. Then we calculate elastic constants at pressures ranging from 0 to 50 GPa in steps of 10 GPa. It is obvious that the Ti2AlX is mechanically stable because all of the elastic constants satisfy the Born stability criteria. The bulk modulus, shear modulus and Young's modulus linearly increase with internal pressure increasing, implying that the pressure can improve the resistance to volume deformation. The ductility and brittleness can be judged according to Pugh's criterion (ratio of bulk modulus to shear modulus B/G), and the brittle nature turns into ductile nature in a pressure range of 40-50 GPa for the Ti2AlX since the value of B/G exceeds 1.75. Finally, we study the thermodynamic properties at various pressures and temperatures based on the quasi-harmonic Debye approximation theory, including the bulk modulus, heat capacity and thermal expansion coefficient. The bulk modulus decreases with temperature increasing but increases with pressure increasing. The heat capacity at constant volume Cv and the heat capacity at constant pressure Cp have the same variation tendency, while Cv obeys the Dulong-Petit limit. It is easy to see that temperature and pressure have opposite influences on heat capacity and the effect of temperature is more significant than that of pressure. The effects of temperature and pressure on linear expansion coefficient mainly occur at low temperature and the effect of pressure is not so considerable when the pressure exceeds 30 GPa. Above all, the effects of temperature and pressure on thermodynamic properties are inverse.

Comparative study on high-pressure physical properties of monoclinic MgCO3 and Mg2CO4

First-principles calculations of high-pressure physical properties anisotropy for magnesite

First-principles study on the high-pressure physical properties of orthocarbonate Ca2CO4

Elastic Stability of CO_{2} Phase I under High Temperature and Pressure

Structural Phase Transformations Of Mg3n2 At High Pressure: Experimental And Theoretical Studies

Phase Transition and Vibration Properties of MnCO3 at High Pressure and High-Temperature by Raman Spectroscopy

A High-Pressure Structural Transition of Norsethite-Type BaFe(CO3)2: Comparison with BaMg(CO3)2 and BaMn(CO3)2

Phase diagram and physical properties of pyrocarbonate CaC2O5: First-principles calculations

DFT study of structural, mechanical, and thermodynamic properties of Mg2C3 crystals under varying pressures: Phase transitions and material behavior

Phase Transitions and Compressibility of Alkali-Bearing Double Carbonates at High Pressures: a First-Principles Calculations Study

Structures and stability of calcium and magnesium carbonates at mantle pressures

First-principle Studies on the Mechanical, Thermodynamic and Electronic Properties of Β″-Mg3gd and Β′-Mg7gd Alloys under Pressure

Phase diagram and physical properties anisotropy of strontianite

High Pressure Experimental Studies on Na3Fe(PO4)(CO3) and Na3Mn(PO4)(CO3): Extensive Pressure Behaviors of Carbonophosphates Family

Structural, Mechanical, and Thermodynamic Properties of Ti2AlX (X = C, N) at High Pressure

Novel high-pressure calcium carbonates

High-pressure Raman Scattering and X-Ray Diffraction Studies of MgTa2O6

Pressure-induced Structural and Semiconductor-Semiconductor Transitions in Co0.5Mg0.5C

First Principles Calculations on Elastic, Thermodynamic and Electronic Properties of Co2Zr and Co2Ti at High Temperature and Pressure

High-pressure Behavior of Ferromagnesite(mg 0.81 Fe 0.19 )CO 3 by Synchrotron X-ray Diffraction and Raman Spectroscopy Up to 53 GPa

Ab-initio insights into the pressure dependent physical properties and possible high-Tc superconductivity in monoclinic and orthorhombic MgVH6