Abstract:The effect of both the Fe : Ni ratio (5 to 1 : 1) and the relative Lewis acidity of a metal oxide support on catalytic activity, selectivity and stability was investigated in the CO2 mediated oxidative dehydrogenation of ethane (CO2-ODH). To avoid effects of varying pore sizes, shapes and volumes of the supports, chromia and zirconia overlayers were coated onto a common γ-Al2O3 carrier (CrOx@Al2O3 and ZrOx@Al2O3). Separately, oxidic FexNiy alloy precursor nanoparticles were prepared using a nonaqueous surfactant-free method and deposited by sonication onto the carrier. In comparison to previous studies in the field, this synthesis technique yields closely associated iron and nickel increasing the chances for alloy formation. During reduction, a mixture of a bcc and a fcc alloy phase was formed, with the content of bcc increasing with increasing iron content as predicted by the bulk phase diagram. Upon exposure to carbon dioxide at elevated temperatures, the bcc metallic phase is selectively oxidised to an inverse spinel structure via the dissociation of CO2. When exposed to CO2-ODH conditions, the bare ZrOx@Al2O3 support shows no activity. The presence of FeNi phases increases the conversion of ethane and CO2 marginally (<2%) but forms ethylene at high selectivity (SC2H4 > 80%). The CrOx@Al2O3 support shows some initial activity (XC2H6 < 5%) at very high ethylene selectivity (SC2H4 > 90%) but deactivates with time on stream. Comparison of the ethane and carbon dioxide conversions suggests that direct dehydrogenation rather than the oxidative pathway is taking place. When FeNi particles with the highest Fe content are added, the ethane conversion behavior hardly changes, but the CO2 conversion is increased now supporting the stoichiometric CO2-ODH reaction (SC2H4 > 95%). It is therefore evident that a tandem catalyst system between a reducible oxide carrier and the FeNi species is required. Increasing the Ni content results in an increase in activity and stability while changing the dominant reaction pathway to a combination of dry reforming, CO2-ODH and possibly the reverse Boudouard reaction, with the latter countering catalyst deactivation through carbon deposition.

About the nickel amount deposited on silica-alumina for ethylene production through oxidative dehydrogenation of ethane

Unraveling the Real Active Sites of an Amorphous Silica–alumina-Supported Nickel Catalyst for Highly Efficient Ethylene Oligomerization

Sol-Gel Preparation, Characterization and Hydrogenation Property of Silica Supported Ni Catalyst

Synthesis of m-phenylenediamine from m-dinitrobenzene over silica-supported nickel catalyst

Ethylene Polymerization with Palygorskite Supported Nickel-Diimine Catalyst

Effect of Metal Oxide–Support Interactions on Ethylene Oligomerization over Nickel Oxide/Silica–Alumina Catalysts

Effect of Oxide Support on Catalytic Performance of FeNi‐based Catalysts for CO2‐assisted Oxidative Dehydrogenation of Ethane

Identification of the structure of Ni active sites for ethylene oligomerization on an amorphous silica-alumina supported nickel catalyst

Partial oxidation of ethane to syngas over nickel‐based catalysts modified by alkali metal oxide and rare earth metal oxide

Supported FexNiy catalysts for the co-activation of CO2 and small alkanes

Green synthesis of Ni-Nb oxide catalysts for low-temperature oxidative dehydrogenation of ethane

Influence of Ni species on the structural evolution of Cu/SiO2 catalyst for the chemoselective hydrogenation of dimethyl oxalate

Insights into the Nature of Selective Nickel Sites on Ni/Al 2 O 3 Catalysts for Propane Dehydrogenation

The Relationship Between Acidity, Dispersion of Nickel, and Performance of Ni/Al-SBA-15 Catalyst on Eugenol Hydrodeoxygenation

Nickle-based catalysts for ethylene oligomerization to alpha-olefin

Influence of the synthesis method parameters used to prepare nickel-based catalysts on the catalytic performance for the glycerol steam reforming reaction

Understanding the electronic metal-support interactions of the supported Ni cluster for the catalytic hydrogenation of ethylene

Partial Oxidation of Methane to Syngas Over Nickel-Based Catalysts: Influence of Support Type, Addition of Rhodium, and Preparation Method

Syngas production employing nickel on alumina‐magnesia supported catalyst via dry methane reforming

Selective Linear Ethylene Oligomerization over Nickel-Containing Zeotypes with Tetravalent Framework Heteroatoms

Plasma‐treated Ni‐Al‐O Catalysts with Variable Physicochemical Properties for the Oxidative Dehydrogenation of Ethane