Abstract:SUMMARY The deca-peptide (TKII-10) was found to have significant anti-angiogenic effect after direct injection into the eye. We attempted to prepare a sustained release formulation of TKII-10 based on the multivesicular liposome structure. Their in vitro and in vivo release profiles and activities were evaluated. INTRODUCTION Therapeutic proteins and peptides administered are often cleared rapidly in vivo and therefore need to be injected frequently in order to maintain therapeutic levels. Various types of liposome formulations had been examined for sustained release of proteins and peptides including multivesicular liposomes [1, . A unique feature of the multivesicular system is that the vesicles contain discontinuous internal aqueous chambers bounded by a continuous non-concentric network of lipid membranes, rendering a higher aqueous volume-to-lipid ratio for higher loading capacity. The deca-peptide (named TKII-10) was developed based on the Arg-Trp sequence of human t-PA kringle 2. It had been shown to have significant anti-angiogenic effect after direct injection into the eye . But it required frequent injection in order to achieve therapeutic efficacy . Therefore we would like to develop a sustained delivery formulation of the peptide and examine their in vitro and on vivo behaviors. EXPERIMENTAL METHODS The multivesicular liposome particles containing TKII10 were prepared based on the typical two-step double emulsification process developed by Kim et al [5, , with a slight modification. Briefly, 1 mL chloroform containing the lipids (molar ratio HSPC: cholesterol: DPPG: triolein, 5:8:1:1) was emulsified for 3 min (10,000 rpm) with 1 mL aqueous solution (the first aqueous solution) containing 82mg TKII-10 and 4% sucrose (w/v), to obtain a waterin-oil emulsion (the first emulsion). A subsequent emulsification for 5 s (7,500 rpm) with a second aqueous solution, 8 mL of 4% glucose (w/v) /20 mM lysine resulted in a ‘water-in-oil-in-water’ double emulsion (the second emulsion). The second emulsion was transferred and added to another aliquot of the aqueous solution in a 100 ml Egg type flask. Chloroform was removed by flushing the surface of the mixture at 37 °C with nitrogen for approximately 15 min. The resultant multivesicular liposomes were harvested by centrifugation for 10 min at 1000 ×g and washed twice with PBS (phosphate-buffered saline) to remove unencapsulated TKII-10. After washing, the particle pellet fraction was resuspended by adding an equal volume of PBS. The whole progress should be kept in sterile environment. All multivesicular liposomes were examined using an Olympus BX61 optical microscopy, and the Malvern Mastersizer 2000 particle sizer. The TKII-10 concentration in MVLs was determined by Waters UPLC & AB SCIEX SelexION Triple Quad 5500 system. The encapsulation efficiency was calculated with the following equation: En (%) = (1Dfree/Dtot) × 100% RESULTS AND DISCUSSION Multivesicular liposomes containing TKII-10 were prepared according to the standard double-emulsion method. The preparations were highly reproducible, usually yielding MVL with similar size distributions and encapsulation efficiencies. A typical particle size distribution profile was shown in Figure 1. The MVL had a size distributions ranging from 7 μm to 30 μm in diameter. The median size was approximately 14 μm and the encapsulation efficiencies was about 86%. Figure 1. Particle size distribution of TKII-10 MVL. A significant advantage of the MVL formulations is its high drug loading capacity. Compared with conventional liposomes, which often have limited encapsulation for hydrophilic proteins, the MVL offered a much larger internal space and had higher encapsulation efficiencies. Triolein was used as a hydrophobic space filler to stabilize the junctions . The in vitro release profile of these MVL particles were assayed at 37°C in 0.5 ml PBS to simulate the environment inside the eye (Figure 2). The duration of release from MVL (7 μm–30 μm) could last for more than 20 days. There was an initial burst release during the first three days and the release rate slowed down and was quite consistent afterwards. Further optimization would be helpful to tune the release profile for therapeutic applications. Figure 2. TKII-10 in vitro release profiles from MVL (4°C and 37°C) in PBS at various incubation time points. n=3. Mean±SD. CONCLUSION In summary, we demonstrated that TKII-10 MVL formulation can achieve high encapsulation efficiency, good stability and sustained release profile. Further optimization is needed in order to develop a clinically valuable sustained release formulation of TKII-10. REFERENCES 1 Lajavardi, L., et al. A. New formulation of vasoactive intestinal peptide using liposomes in hyaluronic acid gel for uveitis. J Control Release, 139 (1) (2009) 22-30. 2 Shen, Y., et al. Multivesicular liposome formulations for the sustained delivery of ropivacaine hydrochloride: preparation, characterization, and pharmacokinetics. Drug Deliv, 18 (5) (2011) 361-366. 3 Su, L., et al. In vitro and in vivo antiangiogenic activity of a novel deca-peptide derived from human tissue-type plasminogen activator kringle 2. Biochem Biophys Res Commun, 396 (2010) 1012-1017. 4 Mishra, G. P., et al. Recent applications of liposomes in ophthalmic drug delivery. J Drug Deliv, 2011 (2011) 863734. 5 Kim S, et al. Preparation of multivesicular liposomes. Biochim Biophys Acta, 728 (1983) 339–348. 6 Mantripragada S. A lipid-based depot (DepoFoam technology) for sustained release drug delivery. Prog Lipid Res, 41 (2002) 392–406. ACKNOWLEDGMENTS We would like to thank Department of Ophthalmology, Shanghai First People’s Hospital, affiliated of Shanghai Jiao Tong University for providing TKII-10.

Liposome Encapsulation of the Palmitoyl–KTTKS Peptide: Structural and Functional Characterization

Pentapeptide Prosequence Enhances Expression and Structure Folding of Recombinant Thermomyces Lanuginosus Lipase in Pichia Pastoris

Phospholipid Encapsulation of an Anti-Fibrotic Endopeptide to Enhance Cellular Uptake and Myocardial Retention

The impact of palmitoyl glycyl-histidyl-lysine on phospholipid model membranes

Dermal peptide delivery using enhancer moleculs and colloidal carrier systems. Part II: Tetrapeptide PKEK

Optimized Cutaneous Delivery of Anti-wrinkle Dipeptide KT via Molecular Modification: Preformulation, Permeation, and the Importance of Conjugate Chain Length

Structure Studies of Micelle-Enhanced Polyelectrolyte Microcapsules

Liposomal Encapsulation of Ascorbyl Palmitate: Influence on Skin Performance

Liposome-assisted penetration and antiaging effects of collagen in a 3D skin model

Liposomes Physically Coated with Peptides: Preparation and Characterization.

RELEASING OF ACETYL HEXAPEPTIDE-3 USING A LECITHIN BASED LIQUID CRYSTAL SYSTEM

Thermoresponsive Elastin-b-Collagen-Like Peptide Bioconjugate Nanovesicles for Targeted Drug Delivery to Collagen-Containing Matrices

Liquid crystalline nanodispersion functionalized with cell-penetrating peptides improves skin penetration and anti-inflammatory effect of lipoic acid after in vivo skin exposure to UVB radiation

Multilayered collagen-lipid hybrid nanovesicles for retinol stabilization and efficient skin delivery

Preparation, Characterization and ex vivo Skin Permeability Evaluation of Type I Collagen-Loaded Liposomes

The preparation of Multivesicular Liposome formulation of deca-peptide ( TKII-10 ) with sustained release characteristics

Liposomal and Liposomes-Film Systems as Carriers for Bioactives from Paeonia tenuifolia L. Petals: Physicochemical Characterization and Biological Potential

A Lipidated Peptide with Mitochondrial Membrane Localization in Human A549 Lung Cells: from Enhanced Cell-Penetrating Properties to Biological Activity Mechanism.

Liposomes as Carriers of GHK-Cu Tripeptide for Cosmetic Application

Recombinant Synthesis of Hybrid Lipid-Peptide Polymer Fusions that Self-Assemble and Encapsulate Hydrophobic Drugs

Controlled release and biological properties of prochitosomes loaded with Arthrospira derived peptides: Membrane stability, chemical, morphological and structural monitoring