Abstract:The wind energy exploitation technique has been developed very quickly in recent years. The vertical axis wind turbine is a hot research domain due to several advantages: low noise, flexible for installation, ease of maintenance, great safety and credibility, etc. The aerodynamic performances of different forms of airfoils including an active deformation airfoil and a fluid-solid coupling passive airfoil with two-dimensional (2D) and three-dimensional (3D) cases have been investigated numerically in this paper. Firstly, the aerodynamic performances of the airfoils with the maximum deformation amplitudes of their cambers which are 3%, 5% and 7% of the chord length have been discussed, respectively, with the angles of attack in the range of 0° and 20°. Secondly, for the angle of attack set at 18°, the two-way fluid-solid coupling simulations with the Young’s Modulus of 1 Mpa and 2 Mpa have also been investigated. Results show that: (1) for the pseudo 3D and real 3D single active deformation airfoil cases, the lift coefficients increase as the maximum deformation amplitudes augment from 3% to 7% of the chord length at the same angle of attack. With the same maximum deformation amplitude, when the angles of attack increase from 0° to 20°, the lift coefficients which increase firstly and then decrease are bigger than that of the original NACA0012 airfoil. When the maximum deformation amplitude of the pseudo 3D airfoil reaches 5% of the chord length, a relatively good aerodynamic performance with better inhibition effect of vortex generation can be obtained. The 3D vortex distribution demonstrates that the deformable airfoil has a better vortex generation controlling effect at the middle cross-section along the spanwise direction than the non-deformable airfoil. (2) From the aspect of fluid-solid coupling, the lift increases and the drag decreases so that the lift to drag ratio has a big improvement when the Young’s Modulus is equal to 1 Mpa and 2 Mpa. The deformable airfoil can inhibit the generation and the shedding of the surface vortex when the fluid-solid coupling effect is considered.

Mechanism Study of Flow Characteristics on small HAWT Blade Surfaces Based on Airfoil Concavity under Yaw Conditions

Optimization Design of a Turbine Blade to Reduce Secondary Flow Loss Using a Viscous Adjoint Method

Secondary Flow Reduction By Blade Redesign And Endwall Contouring Using An Adjoint Optimization Method

A New Flow Control and Efficiency Enhancement Method for Horizontal Axis Wind Turbines Based on Segmented Prepositive Elliptical Wings

Unsteady aerodynamic characteristics of a horizontal wind turbine under yaw and dynamic yawing

Numerical study of flow in low-pressure turbines with undulated suction surface

Swept Blade for Performance Improvement on a Vertical Axis Wind Turbine

Wind tunnel and numerical study of a small vertical axis wind turbine

Wind tunnel experiments for innovative pitch regulated blade of horizontal axis wind turbine

An Experimental Study on Self-Output-control Characteristics of Micro Downwind Rotor with Coning Soft Blades

A NEW ACTIVE CONTROL STRATEGY FOR WIND-TURBINE BLADES UNDER OFF-DESIGN CONDITIONS

Flow fields and losses downstream of an ultra-highly loaded turbine cascade with bowed blades

A Study on the Capability of Backward Swept Blades to Mitigate Loads of Wind Turbines in Shear Flow

Numerical Study on Aerodynamic Performance of Different Forms of Adaptive Blades for Vertical Axis Wind Turbines

Aerodynamic and Aeroelastic Characteristics of Flexible Wind Turbine Blades under Periodic Unsteady Inflows

Investigation on the Performance of a Novel Forward-Folding Rotor Used in a Downwind Horizontal-Axis Turbine

Flow analysis and sensitivity study of vertical-axis wind turbine under variable pitching

Theoretical investigation of the power curve of small HAWT by combining aerodynamic and mechatronic systems

Research on the rotor speed and aerodynamic characteristics of a dynamic yawing wind turbine with a short-time uniform wind direction variation

The effects of the dual control method on the aerodynamic characteristics of the wind turbine blade