Abstract:The new power system with increasingly high renewable energy proportion necessitates the combined heating and power (CHP) generation units to provide more flexibility. With full consideration of operation characteristics, this paper firstly proposes an advanced coal-fired CHP-CAES system consisting of a 350 MW coal-fired CHP unit and a 30 MW CAES system, which realizes more efficient energy utilization and enhances the system adjusting flexibility through thermal cycles integration and energy comprehensive utilization. The thermodynamic models and multi-dimensional performance analysis models are separately established. Based on that, the comparative study is conducted for two CHP-CAES configurations and the stand-alone CHP unit. With 80% heating load, the minimum power ratio is lowered by 11.69% rated power and the maximum power output is increased by 6.35% rated power, and 27.26 tons of coal can be saved for a single cycle compared with the stand-alone CHP unit. The results also demonstrate that the system still has superiority when the load ratio changes. Techno-economic evaluations for a typical application scene show that the dynamic payback period of the proposed system is shortened by 10.41 years compared with the reference separate CHP-CAES system. These results show that the proposed system presents better performance in energy utilization, enhancing flexibility, realizing clean and low-carbon heating as well as techno-economics. In addition, parametric analysis is implemented to find the influence of CAES parameters on the system. It is found that increasing the expander inlet temperature and air storage pressure can further enhance the system round-trip performance. Yet, the investment cost increases greatly for higher storage pressure and the payback period will be lengthened. Furthermore, the system advantages are strengthened with a CAES system of greater capacity. Nevertheless, we find that the deep coupling in the thermodynamic cycle of the two systems results in an upper capacity for the integrated CAES system, and it is nearly 35 MW for the studied system. These regularities and conclusions can provide theoretical guides and directions for the customized CAES system design with the purpose to integrate with a coal-fired CHP unit.

Dynamic availability of energy storage in district heating networks for automatic generation control of a CHP plant

Exploiting Flexibility of District Heating Networks in Combined Heat and Power Dispatch

Optimal Coordination of Chp Plants with Renewable Energy Generation Considering Substitutability Between Electricity and Heat

HVAC Scheduling for Demand Response in a Distributed CCHP System Considering Latent Load

Energy Management of CHP-Based Microgrid with Thermal Storage for Reducing Wind Curtailment

Coordinated Heat and Power Dispatch of Microgrid Considering Two-dimensional Controllability of Heat Loads

Wind-CHP Generation Aggregation with Storage Capability of District Heating Network

Hierarchical Autonomous Cooperative Operation of District Integrated Heating and Power System

Integrated Energy System Optimal Operation Using Data-Driven District Heating Network Model

Heat–power Decoupling for the CHP Unit by Utilizing Heat Storage in the District Heating System Integrated with Heat Pumps: Dynamic Modeling and Performance Analysis

Operational Reliability Assessment of Integrated Heat and Electricity Systems Considering the Load Uncertainties.

Combined Heat and Power Dispatch Considering Pipeline Energy Storage of District Heating Network

Optimization of combined cooling, heating and power with energy storage using an absorption chiller and energy storage control strategy

Thermodynamics, flexibility and techno-economics assessment of a novel integration of coal-fired combined heating and power generation unit and compressed air energy storage

Dynamic Modelling and Simulation of a Combined-Cycle Power Plant Integration with Thermal Energy Storage

Dynamic simulation on the frequency regulation ability enhancement with energy stored in steam distribution system for a combined heat and power unit

Evaluation of Combined Cooling, Heating and Power (CCHP) Systems with Energy Storage Units at Different Locations

A General Model for Thermal Energy Storage in Combined Heat and Power Dispatch Considering Heat Transfer Constraints

District Energy System Modeling and Optimal Operation Considering CHP Units Dynamic Response to Wind Power Ramp Events

Stochastic optimal dispatch of combined heat and power integrated AA-CAES power station considering thermal inertia of DHN

Research on Configuration and Operation of the CCHP System Applicable to Active Distribution Network