Abstract:Electropermeabilization (electroporation) has been used widely for incorporation of xenomolecules (up to the size of DNA) into eukaryotic cells without loss of cellular functions. Frequently, low-cost equipment is used which delivers exponentially decaying field pulses of low intensity and millisecond duration time. This together with the use of disposable cuvettes equipped with aluminum plate electrodes can considerably reduce the survival of the cells and the incorporation of xenomolecules because of the detrimental side effects of long-duration pulses and the toxicity of Al3+-ions on permeabilized cells. Atomic absorption spectroscopy showed that substantial amounts of Al3+-ions (up to 1 mM) were solubilized from the electrodes upon pulsing. Solubilization of Al3+-ions occurred because of the changes of the pH close to the electrodes induced by electrolysis of water. The local pH-changes could be visualized by the addition of pH-indicators together with agarose to the pulse medium. In contrast, when using short pulses of 40 μs to 100 μs duration, small amounts of Al3+-ions were only solubilized from the electrodes upon pulsing. Electroinjection of the plasmid pEGFP-C1 (encoding for Enhanced Green Fluorescence Protein) in four different (murine and human) cell lines showed that relatively high survival rates of cells and species-specific transfection yields (of up to 50–70% as measured by FACS analysis) could be obtained by using aluminum electrodes provided that short-duration pulses were applied. These yields were in the range obtained by using stainless steel electrodes. The required short-duration pulses and field strengths for field-induced incorporation of pEGFP-C1 were achieved using a novel power supply (maximum output voltage of 1.2 kV, pulse durations between 15 μs and 500 μs) in combination with strongly hypo-osmolar pulse media.

High efficiency electrotransfection with aluminum electrodes using microsecond controlled pulses