Abstract:This research aims to design and construct an electronic notice as an alternative to the traditional signpost parting on walls and billboards by providing practical, reliable and proper information dissemination. They consist of the following units, the power supply, voltage regulators, GSM modules, microcontroller, LED dot matrix display board, counter and subscriber identity module (SIM). The power supply comprises a 240/9 v ac 50 Hz step-down transformer rectifier filter and voltage regulations. AT89852, a low-power, high-performance CM05 8-bit microcontroller with 8 k bytes in-system programmable flash memory, is used in this design. A constant five v de is required to power microcontrollers and their associated input/output channel. GSM Modern is a wireless device that works with a GSM wireless network. The counter circuit of the device used to achieve this type of counting is the 5-stage Johnson decade counter. It is a typical chip in the 74HC555, with ten decoded outputs that go high one at a time. The assembler used for this research is MLAB version 5.7, downloaded from the microchip website. This window-based integrated development environment (IDE) software supports the PIC and other microcontrollers. The project constitutes both the software and hardware section for successful implementation. Operation more focus was given to the contribution of the system hardware. For verification of proper functionality of the message board, variation tests carry out and their results. Each component was carefully tested, and hardware troubleshooting and software debugging were carried out. The message was sent, and it appeared and started moving from left to right. In conclusion, by introducing the concept of wireless technology in communication, we can make our communication more efficient and faster with excellent efficiency, and the message can be displayed with less error and maintenance. This model can be used efficiently in establishments like colleges where in-order and special discounts can be displayed simultaneously at all branches. It is therefore recommended as a conventional model can say more than one message at a time LEDS have a limitation on size and a good number of characteristics. These can be replaced with large LED display boards, which not only catch bulb display attributes in a moving position one after another.

IoT Based Real Time LED Display Board

IoT CONTROLLED LED NOTICE BOARD

IoT Sensor-based sustainable smart home management for human needs through Micro Controller

IoT Based Water Quality Management System using ESP32

IOT BASED REAL TIME FEEDBACK SYSTEM

Industrial monitoring and control system using IoT

Low Power and Energy Efficient Street Light System Using IoT

IOT BASED SMART HOME by USING ATmega328 MICROCONTROLLER

Design and Implementation of an IoT-Enabled Smart Street Lighting System using STM32 Microcontroller and ESP32

An IoT Based Real-Time Environmental Monitoring System Using Arduino and Cloud Service

An Automation system over Cloud by Using Internet of Things Applications

Smart timetable display for students’ subject allocation in classroom using IOT

IOT SYSTEM FOR CAR PARKING, STREET LIGHTS, AND AUTOMATIC IRRIGATION WITH REAL-TIME UPDATES ON MOBILE APP

IoT - Based of Automatic Electrical Appliance for Smart Home

IoT enabled Smart Switch With user-friendly Electrical Interfacing

IoT based on Smart Traffic Lights and Streetlight System

Design and Construction of a Modified SMS-Based Electronic Notice Board

IOT Based Smart Lamp for Efficient Usage of Electrical Energy

Development of a Smart Home Automation System using IoT enabled Devices

IoT ENBALED SMART AQUARIUM FOR MONITORING THROUGH SENSORS