Abstract:The development of nanocomposite photocatalysts with high photocatalytic activity, cost-effectiveness, a simple preparation process, and scalability for practical applications is of great interest. In this study, nanocomposites of TiO2 Degussa P25 nanoparticles/activated carbon (TiO2/AC) were prepared at various mass ratios of (4:1), (3:2), (2:3), and (1:4) by a facile process involving manual mechanical pounding, ultrasonic-assisted mixing in an ethanol solution, paper filtration, and mild thermal annealing. The characterization methods included XRD, SEM-EDS, Raman, FTIR, XPS, and UV-Vis spectroscopies. The effects of TiO2/AC mass ratios on the structural, morphological, and photocatalytic properties were systematically studied in comparison with bare TiO2 and bare AC. TiO2 nanoparticles exhibited dominant anatase and minor rutile phases and a crystallite size of approximately 21 nm, while AC had XRD peaks of graphite and carbon and a crystallite size of 49 nm. The composites exhibited tight decoration of TiO2 nanoparticles on micron-/submicron AC particles, and uniform TiO2/AC composites were obtained, as evidenced by the uniform distribution of Ti, O, and C in an EDS mapping. Moreover, Raman spectra show the typical vibration modes of anatase TiO2 (e.g., E1g(1), B1g(1), Eg(3)) and carbon materials with D and G bands. The TiO2/AC with (4:1), (3:2), and (2:3) possessed higher reaction rate constants (k) in photocatalytic degradation of methylene blue (MB) than that of either TiO2 or AC. Among the investigated materials, TiO2/AC = 4:1 achieved the highest photocatalytic activity with a high k of 55.2 × 10−3 min−1 and an MB removal efficiency of 96.6% after 30 min of treatment under UV-Vis irradiation (120 mW/cm2). The enhanced photocatalytic activity for TiO2/AC is due to the synergistic effect of the high adsorption capability of AC and the high photocatalytic activity of TiO2. Furthermore, TiO2/AC promotes the separation of photoexcited electron/hole (e−/h+) pairs to reduce their recombination rate and thus enhance photocatalytic activity. The optimal TiO2/AC composite with a mass ratio of 4/1 is suggested for treating industrial or household wastewater with organic pollutants.

Optimization of TiO2/ACF Photocatalytic Continuous Treatment of MB Wastewater Based on Response Surface Methodology

Photocatalyst-coated Carbon Microtube Electrodes: Preparation and Characterization of Their Properties and Photocatalytic Degradation of Methylene Blue.

Photocatalytic Membrane Reactor for Degradation of Acid Red B Wastewater

Three-dimensional monolithic TiO 2 /ZIF-8/AgCl/Ag-based photocatalytic microreactor for efficient degradation of organic pollutants

Exploring the viability of a floating photocatalyst in a continuous stirred tank reactor system for continuous water treatment

Response Surface Methodology: Photocatalytic Degradation Kinetics of Basic Blue 41 Dye Using Activated Carbon with TiO2

Carbon/Mn3O4/SrTiO3 Microsphere Photocatalyst for the Efficient Removal of High-Concentration Methylene Blue from Water

Strategy for the advanced treatment of simulated tail water of dyeing wastewater based on a short-cut photocatalysis/algal degradation hybrid technology

Efficient photocatalytic degradation of aqueous organic pollutants by using an advanced TiO2/Ti3C2/montmorillonite composites

Siphon-driven Interfacial Photocatalytic Reactors Enhanced by Capillary Flow for Continuous Wastewater Treatment

Preparation of reusable UHMWPE/TiO2 photocatalytic microporous membrane reactors for efficient degradation of organic pollutants in water

Combination Of Plasma Oxidation Process With Microbial Fuel Cell For Mineralizing Methylene Blue With High Energy Efficiency

Photocatalytic reactor design and its application in real wastewater treatment using TiO2 coated on the stainless-steel mesh

Degradation of methylene blue: optimization of operating condition through a statistical technique and environmental estimate of the treated wastewater.

Efficient catalytic degradation of methylene blue by a novel Fe3+-TiO2@CGS three-dimensional photoelectric system

Facile Preparation Method of TiO2/Activated Carbon for Photocatalytic Degradation of Methylene Blue

Ag2O and NiO Decorated CuFe2O4 with Enhanced Photocatalytic Performance to Improve the Degradation Efficiency of Methylene Blue

Integrated Nanostructures of TiO2/g-C3N4/Diatomite Based on Low-Grade Diatomite as Efficient Catalyst for Photocatalytic Degradation of Methylene Blue: Performance and Mechanism

Synergistic adsorption and photocatalysis study of TiO2 and activated carbon composite

TiO2/activated carbon synthesized by microwave-assisted heating for tetracycline photodegradation

Degradation of Dye Wastewater by a Novel mBT-MPR Visible Light Photocatalytic System