Abstract:Study objective: Patients with communicable diseases may require respiratory isolation to reduce the chance of transmission to health care workers and the public. This project was conducted to determine whether negative-pressure isolation for multiple patients can be achieved quickly and effectively using general hospital space not previously dedicated to respiratory isolation. Methods: The physical therapy gymnasium was the area designated to test the ability to create a negative-pressure isolation environment in a large space. The conversion was planned in advance of an unscheduled drill to convert the space. Four high-efficiency particulate air (HEPA) filtered forced air machines were used to generate negative pressure. The units were vented to the outside air by a 25-foot length of 10-inch-diameter reusable duct. We evaluated the time needed for equipment setup and room conversion and noted any subjective difficulty with either setup or operation of the equipment. We measured the ability of the equipment to generate a negative air pressure relative to adjacent areas and determined the noise levels created during the use of different combinations of machines at various power settings. Results: After drill activation and the request for equipment setup, 1 hour was required to convert the physical therapy gymnasium into an operational negative-pressure environment. The room pressure readings "high" power ranged from -1.5 to -13 Pa (-0.006 to -0.052 inches of water), and noise levels ranged from 70 to 76 dB. Calculated air changes per hour using 1, 2, 3, or 4 units running simultaneously at "high" power were 4.1, 8.2, 12.3, and 16.4, respectively. Using 4 units at once running at "low" power setting yielded 8.2 air changes per hour and generated a room pressure reading of -8.0 Pa, or -0.032 inches of water. Conclusion: Portable HEPA filtered forced air units are an effective means of creating large patient care areas with the negative-pressure environment required for respiratory isolation. This design results in a significantly lower-cost alternative compared with construction of individual rooms or units with similar capability and can be retrofitted to existing space. This type of unit would allow treatment of many more patients than current hospital capability would permit and would be an important asset in meeting the needs created by bioterrorism or a naturally occurring epidemic.

Conversion of a regular patient room to negative pressure at Ancona university hospital (Italy). A combined experimental and numerical investigation

Numerical Comparison of the Efficiency of Mixing Ventilation and Impinging Jet Ventilation for Exhaled Particle Removal in a Model Intensive Care Unit

Assessment of displacement ventilation systems in airborne infection risk in hospital rooms

Investigation on the contaminant distribution with improved ventilation system in hospital isolation rooms: Effect of supply and exhaust air diffuser configurations

Study on the migration characteristics of bioaerosols and optimization of ventilation patterns in a negative pressure isolation ward considering different patient postures

Use of a portable forced air system to convert existing hospital space into a mass casualty isolation area

Spatial and temporal distribution of bioaerosols produced by patients with different postures in a negative pressure isolation ward under different ventilation modes

Hospital ventilation simulation for the study of potential exposure to contaminants

Effect of portable negative pressure units on expelled aerosols in the operating room environment

Numerical performance of CO2 accumulation and droplet dispersion from a cough inside a hospital lift under different ventilation strategies

Numerical modelling of ventilation strategies for mitigating cough particles transmission and infection risk in hospital isolation rooms

Assessment of COVID-19 infection Risk, thermal Comfort, and energy efficiency in negative pressure isolation wards with varied ventilation modes

Development of ventilation design strategy for effective removal of pollutant in the isolation room of a hospital

Ventilation improvement for effective protection of healthcare workers in negative pressure airborne infectious isolation room from viral aerosols

Numerical Study of Three Ventilation Strategies in a prefabricated COVID-19 inpatient ward

CFD Investigation of Ventilation Strategies to Remove Contaminants from a Hospital Room

CFD Evaluation of Respiratory Particle Dispersion and Associated Infection Risk in a Coach Bus with Different Ventilation Configurations

Dispersion of exhalation pollutants in a two-bed hospital ward with a downward ventilation system

Evaluation of an innovative pediatric isolation (PI) bed using fluid dynamics simulation and aerosol isolation efficacy

Positive or negative? The pressure control impact in hybrid ventilated hospitals

Performance of low-volume air cleaner and local exhaust in mitigating airborne transmission in hospital outpatient rooms