Abstract:The critical resolved shear stress (CRSS) and its related plastic deformation of titanium with hexagonal close packed structure are highly anisotropic, leading to low ductility of the material. Understanding the alloying effect on the CRSS is crucial for the improvement of the mechanical properties through rational composition design. Accurate prediction of the CRSS is not straightforward due to the atomic randomness of the alloy. The generalized stacking fault energies (GSFEs) for the basal and prismatic plane <math>〈a〉</math> slips of random α-Ti1−xAlx alloys (<math>0≤x≤0.1875</math>) are calculated by using first-principles methods including exact muffin-tin orbitals (EMTO) and plane-wave psuedopotential (VASP) methods in this work. The random distribution of Al in the alloy is treated by using both coherent potential approximation (CPA) for EMTO and special quasirandom structure (SQS) techniques for VASP. The CRSSs are then evaluated within the frame work of semi-discrete variational Peierls-Nabarro model. The VASP-SQS calculations with atomic relaxation generate reasonably good GSFE and CRSS compared with the EMTO-CPA and VASP-SQS calculations without atomic relaxation. For pure Ti, the unstable stacking fault energy (<math>γusf</math>) and CRSS (<math>τa</math>) for the basal <math>〈a〉</math> slip are higher than those for the prismatic <math>〈a〉</math> slip. With increasing Al concentration x, <math>γusfb</math> for the basal <math>〈a〉</math> slip decreases whereas <math>γusfp</math> for the prismatic <math>〈a〉</math> increases. The CRSSs for the basal <math>〈a〉</math> slip (<math>τab</math>) and the prismatic <math>〈a〉</math> slip (<math>τap</math>) both increase with x while <math>τap</math> increases faster than <math>τab</math> such that <math>τab</math> approaches to <math>τap</math>. The calculated CRSSs explain successfully our recently measured mechanical properties (yield strength, fracture toughness, ultimate strength, and elongation) of the α-Ti1−xAlx alloy against x.

First-principles studies of intrinsic stacking fault energies and elastic properties of Al-based alloys

Effect of Alloying Elements on Lattice Misfit and Elasticities of Ni-based Single Crystal Superalloys by First-Principle Calculations

The first-principles calculations for the elastic properties of Zr2Al under compression

The Structural, Elastic And Thermodynamic Properties Of Intermetallic Phases In Mg-Sn-Si-Ca(Sr) Alloys: A First-Principles Study

Generalized stacking fault energies and critical resolved shear stresses of random α-Ti-Al alloys from first-principles calculations

First-principle study of the basal-plane stacking fault energies of ternary Mg alloys

First Principles Studies of Stacking Fault Energies in Ternary Magnesium Alloys

Comprehensive ab initio study of effects of alloying elements on generalized stacking fault energies of Ni and Ni$_3$Al

Insight into the stacking fault energy, dislocation, and thermodynamic properties of L12-Al3X(X Sc, Ti, V) intermetallics from first-principles calculations

Effect of alloying elements on elastic properties, generalized stacking fault energy, and critical resolved shear stress of Pd metal: A first principle study

First-principles calculations for understanding microstructures and mechanical properties of co-sputtered Al alloys

Computational Thermodynamic and First-Principles Calculation of Stacking Fault Energy on Ternary Co-based Alloys

Effect of strain on generalized stacking fault energies and plastic deformation modes in fcc-hcp polymorphic high-entropy alloys: A first-principles investigation

Co-based alloys design based on first-principles calculations: Influence of transition metal and rare-earth alloying element on stacking fault energy

Screening of generalized stacking fault energies, surface energies and intrinsic ductile potency of refractory multicomponent alloys

Generalized Stacking Fault Energy of Al-Doped CrMnFeCoNi High-Entropy Alloy

Effect of Alloying Elements on the Stacking Fault Energy and Ductility in Mg 2 Si Intermetallic Compounds

First-Principles Study on Stacking Fault Energy of γ-Fe–Mn Alloys

Effects of Alloying Elements on the Stacking Fault Energies of Ni58Cr32Fe10 Alloys: A First-Principle Study

The Effects of Alloying Elements on Generalized Stacking Fault Energies, Strength and Ductility of Gamma '-Ni3al

First-principles study of crystal structure prediction, electronic, thermodynamic and mechanical properties of Al-Li binary system