Abstract:It still remains challenges to develop efficient, sensitive yet low-cost electrochemical sensing platforms for quantification of heavy metal ions. Herein, by combining experiments and theoretical calculations, a novel boron-modified bio-carbon (B-bioC) electrode material prepared by ultrasonic-assisted hot impregnation with cotton stalk and inexpensive boric acid and subsequent pyrolysis strategy is initially proposed for simultaneous electroanalysis of cadmium (Cd), lead (Pb) and copper (Cu) using differential pulsed anodic stripping voltammetry (DPASV). The physico-chemical characterizations together with electrochemical characterizations suggested that a higher graphitization level for B-bioC was obtained by the catalytic graphitization effect of metalloid boron, thus rendering lower impedance and faster electron-transfer rate compared with pristine bio-carbon. Also, stronger electrocatalytic activity was observed as a results of the introduction of various boron-bonding electroactive sites (CxBOy(H)). These combined unique advantages make a great role for the enhanced electroanalytical properties of the modified electrodes (B-bioC/MEDs) with a linear response of Cd2+, Pb2+, and Cu2+ concentration range of 0.25–40 μM, 0.06–4.8 μM, and 0.125–20 μM, with sensibility of 10.54, 509.96, and 22.38 μA μM−1 cm−2, and detection limit low to 54, 4, and 24 nM (S/N = 3), respectively, which are comparable to certain reported metal-modified bio-carbons. Finally, through DFT calculations, it was concluded that C-BO2 on B-bioC was the optimum active site over seven B-bonding configurations. This work throws light on the pivotal roles of B configurations in electrochemical sensing and provides theoretical support for deliberately designing ultrasensitive bio-carbon based electrochemical sensing platforms toward heavy metal ions of interest.

Biofilm's morphology design for high sensitivity of bioelectrochemical sensor: An experimental and modeling study

Artificial electrochemically active biofilm for improved sensing performance and quickly devising of water quality early warning biosensors

Electrically Conductive Metal–Organic Framework Thin Film‐Based On‐Chip Micro‐Biosensor: A Platform to Unravel Surface Morphology‐Dependent Biosensing

An electroactive biofilm-based biosensor for water safety: Pollutants detection and early-warning

Dual-signal-biosensor Based on Luminescent Bacteria Biofilm for Real-Time Online Alert of Cu(II) Shock

Simulation of Electrical Biofilm Impedance to Determine the Sensitivity of Electrode Geometries

FeS2 nanoparticles decorated carbonized Luffa cylindrica as biofilm substrates for fabricating high performance biosensors

An antibiotic composite electrode for improving the sensitivity of electrochemically active biofilm biosensor

Dominating Contribution of Intracellular Electron Generation over Extracellular Electron Transfer in Signaling Toxic Formaldehyde Exposure in Electrochemically Active Biofilm Sensors

Titanium mesh as the anode of electrochemically active biofilm sensor for improved sensitivity in water toxicity real-time early-warning.

Ultra-sensitive detection of multiplexed heavy metal ions by MOF-derived carbon film encapsulating BiCu alloy nanoparticles in potable electrochemical sensing system

Impact of microelectrode geometry and surface finish on enzymatic biosensor performance

Layered Design of a Highly Repeatable Electroactive Biofilm for a Standardized Biochemical Oxygen Demand Sensor

Enhanced Stability and Detection Range of Microbial Electrochemical Biotoxicity Sensor by Polydopamine Encapsulation

Feasibility investigation and development of microbial electrochemical biosensors for marine pollution monitoring

Biomineralization-mimetic Preparation of Robust Metal-Organic Frameworks Biocomposites Film with High Enzyme Load for Electrochemical Biosensing

Electrochemical Impedance Spectroscopy-Based Sensing of Biofilms: A Comprehensive Review

Microbial electrochemical sensor for water biotoxicity monitoring

Electrochemical sensor based on Bi/Bi2O3 doped porous carbon composite derived from Bi-MOFs for Pb2+ sensitive detection

Advances in the Application of Quorum Sensing to Regulate Electrode Biofilms in Bioelectrochemical Systems

Metallic-like boron-modified bio-carbon electrodes for simultaneous electroanalysis for Cd2+, Pb2+ and Cu2+: Theoretical insight into the role of CxBOy(H)