Abstract:Sensitivity to ultra-high-energy neutrinos ($E>10^{17}$eV) can be obtained cost-efficiently by exploiting the Askaryan effect in ice, where a particle cascade induced by the neutrino interaction produces coherent radio emission that can be picked up by antennas. As the near-surface ice properties change rapidly within the upper $\mathcal{O}$(100m), a good understanding of the ice properties is required to reconstruct the neutrino properties. In particular, continuous monitoring of the snow accumulation (which changes the depth of the antennas) and the index-of-refraction $n(z)$ profile are crucial for an accurate determination of the neutrino's direction and energy. We present an in-situ calibration system that extends the radio detector station with two radio emitters to continuously monitor the firn properties within the upper 40m by measuring the time differences between direct and reflected (off the surface) signals (D'n'R). We determine the optimal positions of two transmitters at all three sites of current and future in-ice radio detectors: Greenland, Moore's Bay, and the South Pole. For the South Pole we find that the snow accumulation $\Delta h$ can be measured with a resolution of 3mm and the parameters of an exponential $n(z)$ profile $\alpha$ and $z_0$ with 0.04% and 0.14% precision respectively, which constitutes an improvement of more than a factor of 10 as compared to the inference of the $n(z)$ profile from density measurements. Additionally, as this technique is based on the measurement of the signal propagation times we are not bound to the conversion of density to index-of-refraction. We quantify the impact of these ice uncertainties on the reconstruction of the neutrino vertex, direction, and energy and find that the calibration device measures the ice properties to sufficient precision to have negligible influence.

A calibration study of local ice and optical sensor properties in IceCube

The Effect of Hole Ice on the Propagation and Detection of Light in IceCube

Refining the IceCube detector geometry using muon and LED calibration data

Calibration LEDs in the IceCube Upgrade D-Egg Modules

An improved mapping of ice layer undulations for the IceCube Neutrino Observatory

A model independent parametrization of the optical properties of the refrozen IceCube drill holes

Design, performance, and analysis of a measurement of optical properties of antarctic ice below 400 nm

A Novel Microstructure-Based Model to Explain the IceCube Ice Anisotropy

A new simulation framework for IceCube Upgrade calibration using IceCube Upgrade Camera system

Simulation study for an in-situ calibration system for the measurement of the snow accumulation and the index-of-refraction profile for radio neutrino detectors

The camera system for the IceCube Upgrade

Deployment of the IceCube Upgrade Camera System in the SPICEcore hole

Operations plans and sensitivities of the IceCube Upgrade Camera System

POCAM in the IceCube Upgrade

Sensitivity of the IceCube Upgrade to Atmospheric Neutrino Oscillations

The IceCube Neutrino Observatory: Instrumentation and Online Systems

Sensor development and calibration for acoustic neutrino detection in ice

IceCube: physics, status, and future

Precision measurement of the index of refraction of deep glacial ice at radio frequencies at Summit Station, Greenland

Infused Ice can Multiply IceCube's Sensitivity

Improved modeling of in-ice particle showers for IceCube event reconstruction