A Wide Stopband Filtering DDPA With Metal Vias and Metal Strips

Dong-Sheng La,Hao Liu,Run-Long Wang,Kang Tian,Mei-Jun Qu
DOI: https://doi.org/10.1109/tap.2024.3350187
IF: 5.7
2024-03-09
IEEE Transactions on Antennas and Propagation
Abstract:In this communication, a wide stopband filtering dense dielectric patch (DDP) antenna (DDPA) with metal vias and metal strips is proposed. The feeding structure consists of a short-circuited microstrip line and a separated slot. Based on this feeding structure, the and modes of DDP are successfully excited. The electric field region of the mode is much smaller than the physical region of DDP. The electric field region of the mode is basically the same as the physical region of DDP. The resonant frequency of mode is close to the resonant frequency of the mode and the passband is formed. Two semicircular DDPs are etched, and two semicircular metal strips are introduced to generate the low-frequency radiation null. Then, ten metal vias are loaded inside the DDP to further change the resonant frequencies of and modes. The ten metal vias also adjust the H-plane radiation pattern of mode and improve the impedance matching of the proposed filtering DDPA. The measured results are basically consistent with the simulated ones. The relative impedance bandwidth is 4.2% (3.08–3.21 GHz). The low-frequency stopband range is 0.1–3.05 GHz, and the high-frequency stopband range is 3.38–7.0 GHz. The filtering DDPA has good sideband selectivity and wide stopband.
telecommunications,engineering, electrical & electronic
What problem does this paper attempt to address?