Abstract:The recently developed tough and self-healing hydrogels, containing a large number of physical bonds, have found widespread applications in bioengineering and soft electronics. Owing to the sophisticated physical interactions and organization, these hydrogels often demonstrate structural heterogeneities, which strongly influence their mechanical performances. Using poly(N,N-dimethyl acrylamide-co-methacrylic acid) hydrogels (P(DMAA-co-MAAc)) with dynamic hydrogen bonds (H-bonds) as a model system, the structural characterization has been carried out in this study using small-angle X-ray scattering (SAXS) and small-angle neutron scattering (SANS) analyses, along with exploring the influence of the structure on the mechanical properties. By systematically tuning the polymer composition, including the monomer fraction and chemical cross-linking density, two different hydrogel regions with distinct mechanical properties were observed: the swollen regions and shrunk regions. The former was mechanically weak, whereas the latter exhibited a tough behavior. Both types of hydrogels were noted to be highly heterogeneous, which results from the nanoscale spatial polymer concentration fluctuations at ∼100 nm scale. Combined with the contrast variation utilizing SANS, the structure parameters, including the polymer volume fraction of the dense and sparse regions, volume fraction occupied in the space, and average correlation length of the long-range and short-range heterogeneous structures, were explored using a scaling model based on a two-phase system composed of the densely and sparsely cross-linked regions. Using in situ SAXS, the microscopic deformation of the tough and shrunk hydrogels was noted to follow the affine deformation, while a significantly non-affine deformation was observed in the swollen hydrogels, which might have led to the different mechanical performances of these materials.The Supporting Information is available free of charge at https://pubs.acs.org/doi/10.1021/acs.macromol.1c01064.Swelling volume ratio of hydrogels 0.14-0.2% during the drying–swelling cycle (Figure S1); FT-IR spectra of PDMAA, PMAAc, and P(DMAA-co-MAAc) and temperature dependence of FT-IR spectrum of P(DMAA-co-MAAc) (Figure S2); semi-empirical quantum chemical calculations for revealing the conformation features and their interaction in water (Figure S3); tensile stress–strain curves of P(DMAA-co-MAAc) hydrogels f-0.1% with various f values (0.12, 0.13, and 0.15) and P(DMAA-co-MAAc) hydrogels 0.14-x with various x values (0.05, 0.1, and 0.15%) (Figure S4); 1D scattering intensity as a function of the scattering vector q under various stretch ratios for the hydrogels f-0.1% with the molar fraction of DMAA varying from 0.12 to 0.15 and hydrogels 0.14-x with the chemical cross-linking density ranging from 0.05 to 0.15% (Figures S5 and S6); stretch-induced structure evolution of the swollen hydrogel 0.14-0 (Figure S7); tensile stress–strain curve of hydrogel 0.14-1% and the corresponding Mooney–Rivlin plot (Figure S8); and structural parameters of the swollen and shrunk hydrogels (Table S1) (PDF)This article has not yet been cited by other publications.

Multi-scale mechanical and transport properties of a hydrogel

Understanding the Dissociation of Hydrogen Bond Based Cross-Links In Hydrogels Due to Hydration and Mechanical Forces

Multi-physically Cross-Linked Hydrogels Simultaneously with MPa Level Mechanical Strengths and High Equilibrium Water Content above 70 %

Molecular dynamic simulations of the water absorbency of hydrogels

Interaction of epoxy-based hydrogels and water: A molecular dynamics simulation study

Mechanism Study on Mechanical Properties of Physical–Chemical Hybrid Hydrogels by Coarse-Grained Molecular Dynamics Simulations

Multiscale modeling of hydrogels

Scaling laws to predict humidity-induced swelling and stiffness in hydrogels

Atomistic insights into the mechanical properties of cross-linked Poly(N-isopropylacrylamide) hydrogel

Design of Hybrid Multi-Crosslinked Hydrogel with a Combination of High Stiffness, Elastic Applied in High Temperature and High Salinity Reservoirs

Towards a Chemo-Mechanical Coupled Theory of Physical Hydrogel for Sol–gel Transition Identified by Crosslink Density

Investigation of mechanical properties and the effect of volume fraction of polyacrylamide hydrogel with molecular dynamics simulation

A visco-hyperelastic model for hydrogels with tunable water content

Viscoelasticity and Structures in Chemically and Physically Dual-Cross-Linked Hydrogels: Insights from Rheology and Proton Multiple-Quantum NMR Spectroscopy

Molecular Dynamics Simulation of Hyaluronic Acid Hydrogels

Structural relaxation in a Schiff base‐crosslinked aldehyde modified xanthan gum/gelatin hydrogel: Experimental and numerical validation using linear poroelasticity model

Molecular Dynamics Simulation of Hyaluronic Acid Hydrogels: Effect of Water Content on Mechanical and Tribological Properties.

Mechanical characterisation of hydrogel materials

Predictions of Thermo‐Mechanical Properties of Cross‐Linked Polyacrylamide Hydrogels Using Molecular Simulations

Tough Hydrogels with Dynamic H-Bonds: Structural Heterogeneities and Mechanical Performances

Optimizing the composition of gelatin methacryloyl and hyaluronic acid methacryloyl hydrogels to maximize mechanical and transport properties using response surface methodology