Abstract:This paper proposes a new method for assessing the state of charge (SoC) and identifying the types of different lithium-ion cells used in the battery systems of light electric vehicles. A particular challenge in the development of this method was the SoC estimation time, as the method is intended for implementation in the control system of a bicycle charging station, where the state of charge must be determined immediately after the bicycle is plugged in in order to start the charging process as quickly as possible according to the appropriate charging algorithm. The method is based on the identification of the transfer function, i.e., the dynamic response of the battery voltage to the current pulse. In the learning phase of this method, a database of reference transfer functions and corresponding SoCs for a specific type of battery cell is created. The transfer functions are described by coefficients determined through the optimization procedure. The algorithm for estimating the unknown battery cell SoCs is based on the comparison of the measured voltage response with the responses of the reference transfer functions from the database created during the learning process to the same current signal. The comparison is made by calculating the integral of the square error (ISE) between the response of the specific reference transfer function and the measured voltage response of the battery cell. Each transfer function corresponds to a specific SoC and cell type. The specific SoC of the unknown battery is determined by quadratic interpolation of the SoC near the reference point with the smallest ISE for each battery type. The cell type detection algorithm is based on the fact that the integral squared error criterion near the actual SoC for the actual cell type changes less than the squared error criterion for any other battery cell type with the same SoC. An algorithm for estimating the SoC and cell type is described and tested on several different cell types. The relative error between the estimated SoC and the actual SoC was used as a measure of the accuracy of the algorithm, where the actual SoC was calculated using the Coulomb counting method.

An Algorithm of Charge-Discharge Curve Estimation and Full Charge Capacity Correction for Lithium-ion Battery Module

Fast State-of-Charge Estimation for Lithium-Ion Batteries Using a Simplified Electrochemical Model Without Initial State Restrictions

Open Circuit Voltage - State of Charge Curve Calibration by Redefining Max–min Bounds for Lithium-Ion Batteries

Capacity and State‐of‐charge (SOC) Estimation for Lithium‐ion Cells Based on Charging Time Differences Curves

Calculating Available Charge and Energy of Lithium-Ion Cells Based on OCV and Internal Resistance

A Novel Dual Correction Extended Kalman Filtering Algorithm for The State of Charge Real-Time Estimation of Packing Lithium-Ion Batteries

A Study on State of Charge Estimation Method for Lithium Carbon Fluorides Primary Batteries

Modeling of Lithium-ion Battery for Charging/Discharging Characteristics Based on Circuit Model

Intelligent Learning Method for Capacity Estimation of Lithium-Ion Batteries Based on Partial Charging Curves

State of Charge Estimation of Lithium-Ion Battery Using Energy Consumption Analysis

Online Adaptive Parameter Identification and State-of-Charge Coestimation for Lithium-Polymer Battery Cells

State of charge estimation for LiFePO4 battery via dual extended kalman filter and charging voltage curve

Degradation Behavior Analysis of Iron-Based Commercial Lithium-Ion Cells Using High-Precision Charge/Discharge Capacity Measurements: Effect of the C-Rate on the Capacity Trend

An algorithm for state of charge estimation based on a single-particle model

Transient Thermal and Electrical Characteristics of a Cylindrical LiFeS2 Cell with Equivalent Circuit Model

Charge - discharge cycle performance of lead acid battery for energy storage application

A Method for Estimating the State of Charge and Identifying the Type of a Lithium-Ion Cell Based on the Transfer Function of the Cell

Differential Capacity as a Tool for SOC and SOH Estimation of Lithium Ion Batteries Using Charge/Discharge Curves, Cyclic Voltammetry, Impedance Spectroscopy, and Heat Events: A Tutorial

A Cubature Particle Filter Algorithm to Estimate the State of the Charge of Lithium-Ion Batteries Based on a Second-Order Equivalent Circuit Model

State of charge estimation of lithium-ion battery based on extended Kalman filter algorithm