Abstract:Background Periodontal regeneration aims for the three-dimensional reconstruction of bone defects, and over the years, bone grafts with or without barrier membranes have provided us with promising results. Particulate bone grafts can be classified according to the source of procurement as autografts, allografts, xenografts, and alloplasts. Bioglass, an innovative alloplast that uses silica particles as a matrix incorporated with calcium and phosphorus, has been extensively used as a propitious material for bone regeneration owing to its inherent osteogenic ability and biocompatibility but presents with various disadvantages such as slow degradation rate, low mechanical strength, and fracture resistance. A novel silver (Ag)-gadolinium (Gd)-doped bioglass was fabricated to improve the mechanical properties, biocompatibility, and osteogenic ability when compared with bioglass (control). Materials and methods The Ag- and Gd-doped bioglass network was prepared and assessed for the morphological and structural properties by scanning electron microscopy (SEM) analysis, X-ray diffraction (XRD), and attenuated total reflectance (ATR)-infrared (IR). The cytotoxicity of Gd and Ag-doped bioglass was assessed using the MG63 cell line through the MTT (3-(4,5-dimethylthiazol-2-yl)-2,5 diphenyl tetrazolium bromide) assay at various concentrations and the absorbance of the solution was measured at 570 nm using a microplate reader. The osteogenic ability of the material was assessed by alkaline phosphatase activity and collagen estimation. Results ATR-IR spectroscopy, SEM, and XRD were used to examine the bioglass network doped with Gd and Ag. ATR-IR exhibited classic silicate bands, whereas SEM indicated particles bigger than 5 μm. XRD analysis revealed the production of Na2Ca2Si3O9, Na2Ca4(PO4)2SiO4, and wollastonite. The excellent crystallinity of Na2Ca2Si3O9 provided the bioglass network with good mechanical characteristics. The Gd-Ag-bioglass did not exhibit any toxicity towards the living cells at increasing concentrations from 12.5 µg to 100 µg. The alkaline phosphatase activity was increased by 10% and the collagen estimation remained consistent with bioglass (control). Conclusion In conclusion, the fabrication of the novel Gd-Ag-doped bioglass shows good cytocompatibility and osteogenic ability and shows great potential to enhance bone regeneration.

Fabrication and Properties of the Montmorillonite/Nanobioglass Hybrid Reinforcement from Agroindustrial Waste for Bone Regeneration

Dental Applications of Nanostructured Bioactive Glass and Its Composites.

Promotion of In Vitro Osteogenic Activity by Melt Extrusion-Based PLLA/PCL/PHBV Scaffolds Enriched with Nano-Hydroxyapatite and Strontium Substituted Nano-Hydroxyapatite

Fabrication and Characterization of an Innovative Silver- and Gadolinium-Doped Bioglass for Bone Regeneration

Preparation and osteogenic properties of nanocomposite hydrogel beads loaded with nanometric bioactive glass particles

Comparison of the Effect of Sol-Gel and Coprecipitation Routes on the Properties and Behavior of Nanocomposite Chitosan-Bioactive Glass Membranes for Bone Tissue Engineering

Designing of a Multifunctional 3D-Printed Biomimetic Theragenerative Aerogel Scaffold via Mussel-Inspired Chemistry: Bioactive Glass Nanofiber-Incorporated Self-Assembled Silk Fibroin with Antibacterial, Antiosteosarcoma, and Osteoinductive Properties

Mesoporous bioactive glass as a multifunctional system for bone regeneration and controlled drug release

Synergetic effect of bioglass and nano montmorillonite on 3D printed nanocomposite of polycaprolactone/gelatin in the fabrication of bone scaffolds

Novel Organic–Inorganic Nanocomposite Hybrids Based on Bioactive Glass Nanoparticles and Their Enhanced Osteoinductive Properties

Electrospun Polylactic Acid/Polyethylene Glycol/ Silicate‐Chlorinated Bioactive Glass Composite Scaffolds for Potential Bone Regeneration

Collagen Hybrid Formulations for the 3D Printing of Nanostructured Bone Scaffolds: An Optimized Genipin-Crosslinking Strategy

Facile Fabrication of Hollow Mesoporous Bioactive Glass Spheres: from Structural Behaviour to in Vitro Biology Evaluation

Development and characterization of ceramic-polymeric hybrid scaffolds for bone regeneration: incorporating of bioactive glass BG-58S into PDLLA matrix

Development of Bioactive Hybrid Poly (Lactic Acid)/Poly (Methyl Methacrylate) (PLA/PMMA) Electrospun Fibers Functionalized with Bioglass Nanoparticles for Bone Tissue Engineering Applications

Strontium-releasing mesoporous bioactive glasses with anti-adhesive zwitterionic surface as advanced biomaterials for bone tissue regeneration

Enhancing Mechanical Properties and Biological Performances of Injectable Bioactive Glass by Gelatin and Chitosan for Bone Small Defect Repair

Synthesis, Characterization, and In Vitro Evaluation of Bioactivity

Fabrication of Mineralized Polymeric Nanofibrous Composites for Bone Graft Materials

Silver-releasing bioactive glass nanoparticles for infected tissue regeneration

Composite Fiber Networks Based on Polycaprolactone and Bioactive Glass-Ceramics for Tissue Engineering Applications