Abstract:Modular multilevel converter (MMC) is a novel circuit that has appeared in the last few decades, and has been extensively applied to medium/high voltage scenarios, especially in motor drive owing to its scalability and easy to supply a higher number of output voltage levels. As theoretical analysis shows, the sub-module (SM) capacitor voltage magnitude is positively related to the converter output current amplitude and conversely connected to the fundamental frequency. Therefore, the prime challenge of applying MMC to variable speed drives is that there is a huge voltage oscillation in SM capacitor voltage during low-speed working. An innovative high-frequency voltage injection modality to diminish the fluctuation of the capacitor voltage in variable speed drives is proposed in this paper, in which the frequency of the injected component can be changed with the operating frequency of the converter and the low frequency component of power can be converted into high frequency component. The discussed measure not only significantly reduces the voltage float in capacitor, but also avoids the overmodulation of arm voltage modulation waveform caused by high frequency of injection component when converter works in low frequency. With the improved method, the performance of motor at low frequency is enhanced. Finally, the feasibility and effectiveness of the proposed improved high-frequency voltage injection method are verified by simulation and experiment.

Common-Mode Voltage Reduction of Modular Multilevel Converter Using Adaptive High-Frequency Injection Method for Medium-Voltage Motor Drives

Admittance Reshaping Based on Adaptive Minimum Value of DC-Link Voltage for IPMSM Drive with Small Film Capacitor

Common‐mode Voltage Injection‐based Nearest Level Modulation with Loss Reduction for Modular Multilevel Converters

Low Frequency Operation Control Method for Modular Multilevel Converter Based on Improved Arm Current Prediction

A Modified Carrier-Based PWM Strategy for Common Mode Voltage Elimination and Neutral Point Voltage Balance in a Unidirectional Three-Level Converter for AC Motor Drives

A Hybrid Modular Multilevel Converter Topology with an Improved Nearest Level Modulation Method

Common-Mode Voltage Reduction Scheme for MMC With Low Switching Frequency in AC–DC Power Conversion System

Two Types of Common-Mode Voltage Suppression in Medium Voltage Motor Speed Regulation System Based on Solid State Transformer With Dual DC Bus

Analysis and Injection Control of Circulating Current for Modular Multilevel Converters

A New Control Strategy for Modular Multilevel Converter Operating in Quasi Two-Level PWM Mode

Capacitance Reduction Control for Sub-module of Modular Multilevel Converter Applied in Wind Power Generation

An Improved Low-Frequency Ripple Suppression Method for Modular Multilevel Converter in Variable-Speed Motor Drive Application

A Soft-Switching Current-Source-Inverter-Fed Motor Drive With Reduced Common-Mode Voltage

Common-Mode Voltage Reduction Method Based on Variable Sampling Frequency Finite Control Set-Model Predictive Control for PMSM Drive Systems

Variable Slope Trapezoidal Circulating Current Injection to Attenuate Capacitor Voltage Ripple in Modular Multilevel Converter Based Variable Speed Motor Drives Application

An active cancellation method for the common mode current of the three-phase PWM motor drives

A variable frequency injection method for modular multilevel converters in variable speed drives

Optimal Design of a Submodule Capacitor in a Modular Multilevel Converter for Medium Voltage Motor Drives

Hybrid Selective Harmonic Elimination Pwm for Common-Mode Voltage Reduction in Three-Level Neutral-Point-Clamped Inverters for Variable Speed Induction Drives

A Common-Mode Voltage Elimination Scheme by Reference Voltage Decomposition for Back-to-Back Two-Level Converters

Research on Sub-Module Fluctuating Power Decoupling Strategy for Modular Multilevel Converter-Based Medium-Voltage Motor Drive System with Wide Speed Range