Abstract:Unmanned aerial vehicle (UAV) navigation has recently been the focus of many studies. The most challenging aspect of UAV navigation is maintaining accurate and reliable pose estimation. In outdoor environments, global navigation satellite systems (GNSS) are typically used for UAV localization. However, relying solely on GNSS might pose safety risks in the event of receiver malfunction or antenna installation error. In this research, an unmanned aerial system (UAS) employing the Applanix APX15 GNSS/IMU board, a Velodyne Puck LiDAR sensor, and a Sony a7R II high-resolution camera was used to collect data for the purpose of developing a multi-sensor integration system. Unfortunately, due to a malfunctioning GNSS antenna, there were numerous prolonged GNSS signal outages. As a result, the GNSS/INS processing failed after obtaining an error that exceeded 25 km. To resolve this issue and to recover the precise trajectory of the UAV, a GNSS/INS/LiDAR integrated navigation system was developed. The LiDAR data were first processed using the optimized LOAM SLAM algorithm, which yielded the position and orientation estimates. Pix4D Mapper software was then used to process the camera images in the presence of ground control points (GCPs), which resulted in the precise camera positions and orientations that served as ground truth. All sensor data were timestamped by GPS, and all datasets were sampled at 10 Hz to match those of the LiDAR scans. Two case studies were considered, namely complete GNSS outage and assistance from GNSS PPP solution. In comparison to the complete GNSS outage, the results for the second case study were significantly improved. The improvement is described in terms of RMSE reductions of approximately 51% and 78% for the horizontal and vertical directions, respectively. Additionally, the RMSE of the roll and yaw angles was reduced by 13% and 30%, respectively. However, the RMSE of the pitch angle was increased by about 13%.

Learning-Enhanced Adaptive Robust GNSS Navigation in Challenging Environments

A Robust Position Estimation Algorithm for Low-Cost INS/GPS Integrated Navigation System

GNSS positioning enhancement based on NLOS signal detection using spatio-temporal learning in urban canyons

Enhancing Positioning in GNSS Denied Environments based on an Extended Kalman Filter Using Past GNSS Measurements and IMU

A Tightly Coupled GNSS RTK/IMU Integration with GA-BP Neural Network for Challenging Urban Navigation

Robust Navigation In GNSS Degraded Environment Using Graph Optimization

GNSS performance enhancement using measurement estimation in harsh environment

Angle Robustness Unmanned Aerial Vehicle Navigation in GNSS-Denied Scenarios

INS-Aided GNSS Pseudo-Range Error Prediction Using Machine Learning for Urban Vehicle Navigation

Feature-based GNSS positioning error consistency optimization for GNSS/INS integrated system

A Novel GNSS Quality Control Method With Satellite Geometric Network for Dynamic Urban Positioning

An Adaptive Multi-Mode Navigation Method with Intelligent Virtual Sensor Based on Long Short-Term Memory in GNSS Restricted Environment

Resilient Factor Graph-Based GNSS/IMU/Vision/Odo Integrated Navigation Scheme Enhanced by Noise Approximate Gaussian Estimation in Challenging Environments

LSTM-Based GNSS Localization Using Satellite Measurement Features Jointly with Pseudorange Residuals

A GNSS/INS/LiDAR Integration Scheme for UAV-Based Navigation in GNSS-Challenging Environments

A New GNSS Outlier Mitigation Method for GNSS/INS Integrated System

An adaptive navigation method for a small unmanned aerial rotorcraft under complex environment

GNSS Positioning using Cost Function Regulated Multilateration and Graph Neural Networks

RNN-Based GNSS Positioning using Satellite Measurement Features and Pseudorange Residuals

Residual Attention Network-Based Confidence Estimation Algorithm for Non-Holonomic Constraint in GNSS/INS Integrated Navigation System

Continuous and Precise Positioning in Urban Environments by Tightly Coupled Integration of GNSS, INS and Vision