Abstract:We report a study of the kinetics of dissolution of (100) and (110) single-crystal diamond plates ("D(100)" and "D(110)") in thin films of nickel (Ni) and cobalt (Co). This dissolution occurs at the metal-D(100) or metal-D(110) interface and was studied in the presence and also in the absence of water vapor at temperatures near 1000 degrees C. The single-crystal D(100) dissolves in Ni, and also in Co, in the temperature range 900-1050 degrees C. The dissolution is too slow to measure below 900 degrees C. In an argon (Ar) atmosphere (under an Ar(g) flow at 1000 sccm and 1 atm pressure, with no water vapor present in the reaction chamber) and at any temperature in the range 900-1050 degrees C, the metal film is rapidly saturated with dissolved carbon (C), thin graphite films form on the free metal surface and at the metal-D interface during heating at or above 650 degrees C, and the dissolution of the diamond then stops. For addition of water vapor, its partial pressure was controlled by using a water bubbler immersed in a constant temperature bath and Ar(g) was used as the carrier gas. We discovered two different regimes (I and II) for the kinetics of dissolution of D(100) and D(110), in which the rate-determining step was the removal of carbon atoms on the open metal surface (regime I, lower partial pressure of water vapor) or dissolution of diamond at the metal-diamond interface (regime II, higher partial pressure of water vapor) that yielded different Arrhenius parameters. Time-of-flight-secondary ion mass spectrometry depth profiles show the concentration gradient of C from a certain depth into the metal film surface down to the M-D(100) interface, and residual gas analyzer measurements show that the gas products formed in the presence of water vapor on the metal surface are CO and H2. It was found that the rate of dissolution of diamond in Co was higher than that in Ni for both D(100) and D(110) and for both regimes I and II, and possible reasons are suggested. We also found that D(111) could not be dissolved at the Ni/D(111) and Co/D(111) interface in the presence of water vapor (over the same range of sample temperatures). The reaction paths for dissolution of C at the M-D(100) or M-D(110) interface and for removal of C from the free surfaces of Ni and Co were assessed through density functional theory modeling at 1273 K.

DFT-Based Calculation of Dissolution Activation Energy and Kinetics of Ni–Cr Alloys

Assessment of Mobilities of the B2 Phase in the Nickel-Chromium-Aluminum System

Effect of Cr Doping on the Surface Characteristics of Ni Metal Studied with First-Principles Calculation

Atomic Mobilities and Interdiffusivities in Ni-rich Fcc Ni-Co-Cr and Ni-Al-Co-Cr Systems Evaluated Using Composition Profiles and HitDIC

Spin-polarized DFT calculations of elemental effects on hydrogen atom adsorption on FeCrAl (110) surface

Understanding crystallographic orientation dependent dissolution rates of 90Cu-10Ni alloy: New insights based on AFM/SKPFM measurements and coordination number/electronic structure calculations

Interatomic Fe-Cr potential for modeling kinetics on Fe surfaces

Analysis of Corrosion Potential of Zn, Ni, and Zn-Ni Alloy Using Ab Initio Calculations Supported by Experimental Thermodynamics Data

Effects of Cr-doping on the adsorption and dissociation of S, SO, and SO2 on Ni(111) surfaces

Accelerating Water Dissociation Kinetics of Ni3N by Tuning Interfacial Orbital Coupling

Ab Initio Molecular Dynamics Simulation on Interfacial Reaction Behavior of Fe-Cr-Ni Stainless Steel in High Temperature Water

First Principles Calculations of Alloying Element Diffusion Coefficients in Ni Using the Five-Frequency Model

Experimental study and thermodynamic modeling of the Al-Co-Cr-Ni system

Ab initio study of influence of 3d alloying elements on corrosion properties of non-passivated nickel-base alloys

Thermodynamic Assessment of the Ni–Co–Cr System and Diffusion Study of Its Fcc Phase

The Role of Cr Atom in the Early Steam Oxidation of Fe‐based Alloys: an Atomistic Simulation

The Linear Relationship Between Diffusivity and Crystallization Kinetics in a Deeply Supercooled Liquid Ni50Ti50 Alloy

Dissolving Diamond: Kinetics of the Dissolution of (100) and (110) Single Crystals in Nickel and Cobalt Films

Effects of adsorption of O2 and H2O molecules on the corrosion behavior of the NiTi alloy surface: a DFT investigation

Diffusion behavior of fcc and L12 Ni–Al–Cr alloys

Dissolution of Interdendritic Σ Phase in Cast Ni–Fe–Cr Alloy