Abstract:Purpose: To evaluate the in vitro cleaning effects of different decontamination methods and their impacts on surface characteristics using clinically failed TiUnite implants (Nobel Biocare, Kloten, Switzerland). Materials and methods: Thirty clinically failed TiUnite implants were treated using different decontamination methods. Group 1 (control group) received physiological saline irrigation; Group 2 underwent erythritol powder air polishing (AIRFLOW Master Piezon, EMS Dental, Nyon, -Switzerland); Group 3 was treated with erythritol powder air polishing with ethylenediaminetetraacetic acid brushing (FileRite PRC, Pulpdent, Watertown, MA, USA); Group 4 received ultrasonic scaling with polyetheretherketone tips (EMS Dental); Group 5 underwent ultrasonic scaling with polyetheretherketone tips with ethylenediaminetetraacetic acid; and Group 6 was treated with a combination of ultrasonic scaling with polyetheretherketone tips, erythritol powder air polishing and ethylenediaminetetraacetic acid. Surface cleaning effects, quantified by relative contaminated area reduction and visual analogue scale score, as well as surface roughness and chemistry, were assessed after decontamination. The cleaning effects of each decontamination method were also compared between TiUnite and SLA (sandblasted, large-grit acid-etched; Straumann, Basel, Switzerland) implants. Results: Group 6 showed the highest relative contaminated area reduction (stereoscopic microscopy 83.92%, scanning electron microscopy 96.40%), visual analogue scale score (2.83) and reduction in surface roughness (thread bottom -0.78 mu m, tip -1.35 mu m), as well as an almost maximal decrease in the proportion of carbon (thread bottom -12.33%, tip -8.77%) and increase in that of titanium (thread bottom 13.71%, tip 10.73%). Polyetheretherketone remnants were observed in Groups 4 and 5 but appeared to be reduced in Group 6. When comparing the outcomes with those for SLA implants, no significant differences were found. Conclusion: Within the limitations of the present study, the combination of ultrasonic scaling with polyetheretherketone tips, erythritol powder air polishing and ethylenediaminetetraacetic brushing achieved reasonable cleaning effects. The original surface modification did not seem to have any impact on the decontamination results for any of the methods examined.

In-vitro biofilm removal from TiUnite® implant surface with an air polishing and two different plasma devices

Efficiency of cold atmospheric plasma, cleaning powders and their combination for biofilm removal on two different titanium implant surfaces

In-Vitro Biofilm Removal Efficacy Using Water Jet in Combination with Cold Plasma Technology on Dental Titanium Implants

Electrochemical removal of peri-implantitis associated biofilms from titanium implant surfaces by in-situ anodization

Effect of implant cleaning on titanium particle dissolution and cytocompatibility

Antimicrobial efficiency and cytocompatibility of different decontamination methods on titanium and zirconium surfaces

In vitro evaluation of chemical decontamination of titanium discs

Influence of eight debridement techniques on three different titanium surfaces: A laboratory study

Influence of cold atmospheric plasma on dental implant materials — an in vitro analysis

A novel cold atmospheric pressure air plasma jet for peri-implantitis treatment: An in vitro study.

Effects of a Novel Cold Atmospheric Plasma Treatment of Titanium on the Proliferation and Adhesion Behavior of Fibroblasts

Cleaning Effects of Decontamination Methods on Clinically Failed TiUnite Implants and Their Impacts on Surface Roughness and Chemistry: an in Vitro Pilot Study.

Nonsurgical cleaning potential of deep-threaded implants and titanium particle release: A novel in vitro tissue model

The biofilm removal effect and osteogenic potential on the titanium surface by electrolytic cleaning: An in vitro comparison of electrolytic parameters and five techniques

Inhibition of Bacterial Growth on Zirconia Abutment with a Helium Cold Atmospheric Plasma Jet Treatment.

Cell Response of Titanium Implant with a Roughened Surface Containing Titanium Hydride: an in Vitro Study

Cold Atmospheric Plasma Improves the Colonization of Titanium with Primary Human Osteoblasts: An In Vitro Study

Non-thermal atmospheric pressure plasma treatment increases hydrophilicity and promotes cell growth on titanium alloys in vitro

Surface Decontamination of Titanium Dental Implants Subjected to Implantoplasty by Treatment with Citric Acid Solutions

Effectivity of homecare and professional biofilm removal procedures on initial supragingival biofilm on laser-microtextured implant surfaces in an ex vivo model

Efficacy of Combined Mechanical and Chemical Decontamination Treatments on Smooth and Rough Titanium Surfaces and Their Effects on Osteoconduction: An Ex Vivo Study