Abstract:Introduction Cathode catalysts of polymer electrolyte fuel cells (PEFCs) are subjected to a severe environment with strong acidity and high potential, leading to catalyst degradation [1] . In particular, the degradation of electrocatalysts in fuel cell vehicles is often caused by oxidative corrosion of their carbon support during start-stop cycles, and by dissolution and re-deposition of platinum during load cycles [2] . Our research group has developed electrocatalysts using Nb-doped SnO 2 on carbon support, achieving high start-stop potential durability [3] . The use of Ti and Sn as metal supports instead of carbon has also been considered as a fundamental solution against start-stop related degradation [4] . However, catalytic activity has to be improved, compared to the standard Pt/C catalysts. Here in this study, catalysts using mesoporous carbon (MC) support are prepared using metallic Ta with a high melting point. Parameters such as loading and heat treatment conditions are varied to tailor higher performance and durability of PEFC electrocatalysts. Experimental Ta/MC supports were prepared by steam hydrolysis of an ethoxide reagent on mesoporous carbon (CNovel®, TOYO TANSO) with mesopores of 10 nmΦ. The Pt/Ta/MC catalysts was then prepared by decorating with Pt using the acetylacetonate (acac) method [5] . The microstructure of the prepared Ta/MC supports and the Pt/Ta/MC catalysts was observed using scanning transmission electron microscopy (SU9000, Hitachi High-Tech Corp., Japan). Electrochemical characterization of the catalysts was performed by half-cells: Pt electrochemical surface area (ECSA) was evaluated by cyclic voltammetry (CV), and oxygen reduction reaction activity (ORR activity) was evaluated from the activation-dominant current value by rotating disk electrode (RDE) measurements. The catalysts durability was evaluated by applying potential cycles simulating start-stop and load cycles. Results and discussion As shown in Fig. 1, microstructural observation of the catalyst supports by STEM confirmed that small Ta particles were uniformly supported, and that the Ta particles were impregnated into the mesopores of MCs. EDS elemental analysis was performed to calculate the residual oxygen content. It was found that the reduction of Ta 2 O 5 to Ta proceeded by high-temperature heat treatment in an H 2 atmosphere. The initial activity and durability of the prepared Pt/Ta/MC catalysts were evaluated by half-cell electrochemical measurements. ECSA and mass activity were 78.5 m 2 /g and 179.2 A/g, respectively, showing initial activity approaching that of the standard Pt/C catalyst. Regarding durability, high load cycle durability was confirmed. In this presentation, the microstructure and electrochemical properties of the Pt/Ta/MC catalysts will be presented as alternative cathode catalysts. Acknowledgment This paper is based on results obtained from a project, JPNP20003, commissioned by the New Energy and Industrial Technology Development Organization (NEDO). References [1] T. Takahashi, T. Ikeda, K. Murata, O. Hotaka, S. Hasegawa, Y. Tachikawa, M. Nishihara, J. Matsuda, T. Kitahara, S. M. Lyth, A. Hayashi, and K. Sasaki, J. Electrochem. Soc. , 169 , 044523 (2022). [2] A. Ohma, K. Shinohara, A. Iiyama, T. Yoshida and A. Daimaru, ECS Trans. , 41 (1), 775 (2011). [3] F. Takasaki, S. Matsuie, Y. Takabatake, Z. Noda, A. Hayashi, Y. Shiratori, K. Ito, and K. Sasaki, J. Electrochem. Soc ., 158 (10), B1270 (2011). [4] T. Ikehara, Z. Noda, J. Matsuda, M. Nishihara, A. Hayashi, and K. Sasaki, ECS Trans. , 104 (8), 389 (2021). [5] A. Hayashi, H. Notsu, K. Kimijima, J. Miyamoto, and I. Yagi, Electrochim. Acta , 53 , 6117 (2008). Figure 1

Preparation of Nanocrystalline Nb-Doped SnO2 on Mesoporous Carbon for PEFC Electrocatalysts

PEFC Electrocatalysts Using Sn-Based Materials Dispersed on Mesoporous Carbon

Pt/SnO2 NFs AS AN ACTIVE AND STABLE ORR ELECTROCATALYST FOR POLYMER ELECTROLYTE MEMBRANE FUEL CELL

Engineering Porosity into Trimetallic PtPdNi Nanospheres for Enhanced Electrocatalytic Oxygen Reduction Activity

Synthesis of a Mesoporous SnO 2 Catalyst Support and the Effect of Its Pore Size on the Performance of Polymer Electrolyte Fuel Cells

Highly Durable and Active Electrocatalysts Using Pt Nanorod Catalysts Supported on Nb Doped SnO2 for Polymer Electrolyte Fuel Cells Operating at Wide Temperature Range

Ozone-Assisted Hydrothermal Synthesis Method of Sb-Doped SnO2 Conductive Nanoparticles for Carbon-Free Oxygen-Reduction-Reaction Catalysts of Proton-Exchange-Membrane Hydrogen Fuel Cells

Power Generation Charactristics of Polymer Electrolyte Fuel Cells with Electrocatalysts Supported on SnO2 in High Current Density Range

Multifunctional High-Performance Electrocatalytic Properties of Nb2O5 Incorporated Carbon Nanofibers As Pt Support Catalyst

Pt–SnO2/nitrogen-doped CNT Hybrid Catalysts for Proton-Exchange Membrane Fuel Cells (PEMFC): Effects of Crystalline and Amorphous SnO2 by Atomic Layer Deposition

High electrocatalytic activity of Pt on porous Nb-doped TiO2 nanoparticles prepared by aerosol-assisted self-assembly

Strong Interaction between Titanium Carbonitride Embedded in Mesoporous Carbon Nanofibers and Pt Enables Durable Oxygen Reduction

Ordered SnO2@C Flake Array as Catalyst Support for Improved Electrocatalytic Activity and Cathode Durability in PEMFCs

A Novel CNT@SnO2 Core–sheath Nanocomposite As a Stabilizing Support for Catalysts of Proton Exchange Membrane Fuel Cells

PEFC Electrocatalysts Using Ta-Based Support on Mesoporous Carbon

A novel support for platinum electrocatalyst based on mesoporous carbon embedded with bimetallic SnTi oxide as a bifunctional electrocatalyst

Macroporous Structures of Nb-SnO2 Particles as a Catalyst Support Induce High Porosity and Performance in Polymer Electrolyte Fuel Cell Catalyst Layers

The Development of a Highly Durable Fe-N-C Electrocatalyst With Favorable Carbon Nanotube Structures for the Oxygen Reduction in PEMFCs

A Controllable Synthesis of Pt-Based Electrocatalyst for the Oxygen Reduction Reaction of PEMFC with High Pt Utilization

Rapid Microwave-Assisted Synthesis of Platinum Nanoparticles Immobilized in Electrospun Carbon Nanofibers for Electrochemical Catalysis

Electrospun bimetallic PtNi nanowires as electrocatalyst for oxygen reduction reaction in PEMFCs