Abstract:Despite an interparticle potential consisting of only an infinite repulsion at contact, the thermodynamics and dynamics of concentrated dispersions of hard spheres are not yet fully understood. Colloidal poly-(methyl methacrylate) spheres with a grafted layer of poly-(12-hydroxy stearic acid) (PMMA-PHSA) comprise a common model for investigating structural, dynamic, and rheological properties. These highly monodisperse spheres can be index matched in nonaqueous solvents, reducing van der Waals forces and allowing characterization via Light scattering. In this work, we test the behavior of these dispersions against expectations for hard spheres through observations of the phase behavior, x-ray densitometry of equilibrium sediments, and Zimm viscometry. We set the effective hard sphere volume fraction by the disorder-order transition, thereby accounting for the polymer layer, any swelling due to the solvent, and polydispersity. The melting transition then occurs close to the expected value and the equation of state for the fluid phase, extracted from the equilibrium sediment with x-ray densitometry, conforms to the Carnahan-Starling equation. However, the osmotic pressure of the crystalline phase lies slightly above that calculated for a single fee crystal even after accounting for polydispersity. Likewise the high shear viscosity of the fluid compares well with other hard sphere dispersions, but the low shear viscosity for PMMA-PHSA hard spheres exceeds those for polystyrene and silica hard spheres, e.g., a relative viscosity of 45+/-3 at phi=0.50 rather than 24. Our low shear viscosities are consistent with other PMMA-PHSA data after rescaling for both the polymer layer thickness and polydispersity, and may represent the true hard sphere curve. We anticipate that the equation of state for the crystal deviates due to polycrystallinity or a direct effect of polydispersity.

Density functional theory for colloidal mixtures of hard platelets, rods, and spheres

Bulk fluid phase behaviour of colloidal platelet-sphere and platelet-polymer mixtures

Observation of Isotropic-Isotropic Demixing in Colloidal Platelet-Sphere Mixtures.

Phase Transition, Equation of State, and Limiting Shear Viscosities of Hard Sphere Dispersions

Bulk and interfacial properties of binary hard-platelet fluids

Depletion potential in colloidal mixtures of hard spheres and platelets

Wetting and capillary nematization of binary hard-platelet and hard-rod fluids

Phase Behavior of Mixtures of Colloidal Platelets and Nonadsorbing Polymers

Structures and Correlation Functions of Multicomponent and Polydisperse Hard-Sphere Mixtures from a Density Functional Theory

Density Functional Theory for the Density Profile of Hard- Sphere Chain Fluid Near Solid Plate and Spherical Solid Particle Surface

Density Functional Theory Based on the Universality Principle and Third-Order Expansion Approximation for Adhesive Hard-Sphere Fluid Near Surfaces

A Mixed Order Density Functional Theory for Adhesive Hard Sphere Fluid Confined Between Two Hard Walls

Equilibrium Properties of Hard Sphere Fluid in Confined Geometries: a Density Functional Theory Study

Phase diagram of hard colloidal platelets: a theoretical account

Phase Separation in Mixtures of Colloidal Platelets and Non-Adsorbing Polymer: a Scaled Particle Treatment

Density-functional Theory of Spherical Electric Double Layers and Zeta Potentials of Colloidal Particles in Restricted-Primitive-model Electrolyte Solutions.

Density Functional Theory for Nonuniform Polymer Melts: Based on the Universality of the Free Energy Density Functional

Structures Of Hard-Sphere Fluids From A Modified Fundamental-Measure Theory

Fluids of platelike particles near a hard wall

DENSITY FUNCTIONAL FOR STRUCTURES OF COLLOIDS CONFINED IN A SLIT-LIKE PORE

Density Functional Theory for Inhomogeneous Mixtures of Polymeric Fluids