Great Amplification of Circular Polarization Sensitivity via Heterostructure Engineering of a Chiral Two-Dimensional Hybrid Perovskite Crystal with a Three-Dimensional MAPbI 3 Crystal

Xinyuan Zhang,Xitao Liu,Lina Li,Chengmin Ji,Yunpeng Yao,Junhua Luo

DOI: https://doi.org/10.1021/acscentsci.1c00649

IF: 18.2

2021-07-19

ACS Central Science

Abstract:Chiral hybrid perovskites have brought an unprecedented opportunity for circularly polarized light (CPL) detection. However, the circular polarization sensitivity of such a detector remains extremely low because of the high exciton recombination rate in those single-phase hybrid perovskites. Here, a heterostructure construction strategy is proposed to reduce the electron–hole recombination rate in a chiral hybrid perovskite and achieve CPL detectors with greatly amplified circular polarization sensitivity. A heterostructure crystal, namely, [(<i>R</i>)-MPA]₂MAPb₂I₇/MAPbI₃ ((<i>R</i>)-MPA = (<i>R</i>)-methylphenethylamine, MA = methylammonium), has been successfully created by integrating a chiral two-dimensional (2D) perovskite with its three-dimensional counterpart via solution-processed heteroepitaxy. Strikingly, the sharp interface of the as-grown heterostructure crystal facilitates the formation of a built-in electric field, enabling the combined concepts of charge transfer and chirality transfer, which effectively reduces the recombination probability for photogenerated carriers while retaining chiroptical activity of chiral 2D perovskite. Thereby, the resultant CPL detector exhibits significantly amplified circular polarization sensitivity at zero bias with an impressive anisotropy factor up to 0.67, which is about six times higher than that of the single-phase [(<i>R</i>)-MPA]₂MAPb₂I₇ (0.1). As a proof-of-concept, the strategy we presented here enables a novel path to modulate circular polarization sensitivity and will be helpful to design chiral hybrid perovskites for advanced chiroptical devices.Chiral perovskite heterocrystals have been successfully created to demonstrate a self-driven circularly polarized light detector which achieves an impressive anisotropy factor of up to 0.67.This article has not yet been cited by other publications.

chemistry, multidisciplinary

What problem does this paper attempt to address?

The problem that this paper attempts to solve is to improve the circular polarization sensitivity of circularly polarized light (CPL) detectors. Specifically, the paper mentions that when traditional single - phase chiral hybrid perovskite materials are used as CPL detectors, their circular polarization sensitivity is very low due to the high exciton recombination rate. To solve this problem, the authors propose a heterostructure construction strategy. By combining two - dimensional chiral hybrid perovskite with three - dimensional perovskite to form a heterojunction structure, the electron - hole recombination rate can be effectively reduced, and a CPL detector with significantly amplified circular polarization sensitivity can be realized.

Through this strategy, the researchers successfully prepared the heterostructure crystal \([(R)-MPA]_2MAPb_2I_7/MAPbI_3\), where \((R)-MPA=(R)-methylphenethylamine\), \(MA = methylammonium\). The experimental results show that the CPL detector based on this heterostructure exhibits a significantly amplified circular polarization sensitivity at zero bias voltage, and its anisotropy factor is as high as 0.67, which is approximately six times that of the single - phase \([(R)-MPA]_2MAPb_2I_7\) (0.1). This result indicates that heterostructure engineering can effectively improve the performance of CPL detectors and provides new ideas for designing high - performance chiral hybrid perovskite materials.