Abstract:The MethaneSAT satellite instrument and its aircraft precursor, MethaneAIR, are imaging spectrometers designed to measure methane concentrations with wide spatial coverage, fine spatial resolution, and high precision compared to currently deployed remote sensing instruments. At 12 960 m cruise altitude above ground (13 850 m above sea level), MethaneAIR datasets have a 4.5 km swath gridded to 10 m × 10 m pixels with 17–20 ppb standard deviation on a flat scene. MethaneAIR was deployed in the summer of 2021 in the Permian Basin to test the accuracy of the retrieved methane concentrations and emission rates using the algorithms developed for MethaneSAT. We report here point source emissions obtained during a single-blind volume-controlled release experiment, using two methods. (1) The modified integrated mass enhancement (mIME) method estimates emission rates using the total mass enhancement of methane in an observed plume combined with winds obtained from Weather Research Forecast driven by High-Resolution Rapid Refresh meteorological data in Large Eddy Simulations mode (WRF-LES-HRRR). WRF-LES-HRRR simulates winds in stochastic eddy-scale (100–1000 m) variability, which is particularly important for low-wind conditions and informing the error budget. The mIME can estimate emission rates of plumes of any size that are detectable by MethaneAIR. (2) The divergence integral (DI) method applies Gauss's theorem to estimate the flux divergence fields through a series of closed surfaces enclosing the sources. The set of boxes grows from the upwind side of the plume through the core of each plume and downwind. No selection of inflow concentration, as used in the mIME, is required. The DI approach can efficiently determine fluxes from large sources and clusters of sources but cannot resolve small point emissions. These methods account for the effects of eddy-scale variation in different ways: the DI averages across many eddies, whereas the mIME re-samples many eddies from the LES simulation. The DI directly uses HRRR winds, while mIME uses WRF-LES-HRRR wind products. Emissions estimates from both the mIME and DI methods agreed closely with the single-blind volume-controlled experiments ( N = 21). The York regression between the estimated emissions and the released emissions has a slope of 0.96 [0.84, 1.08], R = 0.83 and N = 21, with 30 % mean percentage error for the whole dataset, which indicates that MethaneAIR can quantify point sources emitting more than 200 kg h −1 for the mIME and 500 kg h −1 for the DI method. The two methods also agreed on methane emission estimates from various uncontrolled sources in the Permian Basin. The experiment thus demonstrates the powerful potential of the MethaneAIR instrument and suggests that the quantification method should be transferable to MethaneSAT if it meets the design specifications.

Investigation of Spectral Bands and Sensor Parameters for Methane Emission Detection Imaging Spectrometer

MethaneMapper: Spectral Absorption aware Hyperspectral Transformer for Methane Detection

Exploiting the entire near-infrared spectral range to improve the detection of methane plumes with high-resolution imaging spectrometers

Spectral Fingerprinting of Methane from Hyper-Spectral Sounder Measurements Using Machine Learning and Radiative Kernel-Based Inversion

Near-Infrared Dual-Range Methane Sensor Using the OAIC-HC Mode Based on VMD-SG-Assisted Optical Noise Suppression

Continuous and real-time indoor and outdoor methane sensing with portable optical sensor using rapidly pulsed IR LEDs

Sensitivity and Uncertainty in Matched-Filter-Based Gas Detection With Imaging Spectroscopy

Methane point source quantification using MethaneAIR: a new airborne imaging spectrometer

Quantifying Methane Emissions from the Global Scale Down to Point Sources Using Satellite Observations of Atmospheric Methane

Using Different Spectroscopic Databases to Model the Transfer of Radiation in the Near-IR Range and Retrieve the Content of Methane in the Atmosphere

Lidar-based gas analyzer for remote sensing of atmospheric methane

Experimental Study on Enhanced Methane Detection Using an MEMS-Pyroelectric Sensor Integrated with a Wavelet Algorithm

Methane Retrieval from Hyperspectral Infrared Atmospheric Sounder on FY3D

Comparison of Sub-Ppm Instrument Response Suggests Higher Detection Limits Could Be Used to Quantify Methane Emissions from Oil and Gas Infrastructure

Evaluating the detectability of methane point sources from satellite observing systems using microscale modeling

An Optimized Methane Retrieval Approach Based on Kalman Filter for Mapping Methane Point Source Emissions from Spaceborne Imaging Spectrometer

A high-sensitive methane measuring telemetry system based on a direct optical absorption technique

Vehicle-Deployed Off-Axis Integrated Cavity Output Spectroscopic CH4/C2H6 Sensor System for Mobile Inspection of Natural Gas Leakage

Detecting Methane Emissions from Space Over India: Analysis Using EMIT and Sentinel-5P TROPOMI Datasets

Miniaturised Infrared Spectrophotometer for Low Power Consumption Multi-Gas Sensing

A Wavelength Modulation Spectroscopy-Based Methane Flux Sensor for Quantification of Venting Sources at Oil and Gas Sites