Abstract:High strength threaded fasteners are widely used in the aircraft industry, and service experience shows that for structures where shear loading of the joints is significant, like skin splices, fuselage joints or spar caps-web attachments, more cracks are initiated and grow from the edges of the fastener holes than from features like fillets radii and corners or from large access holes. The main causes of this cracking are the stress concentrations introduced by the fastener holes and by the threaded fasteners themselves, with the most common damage site being at the edge of the fastener holes. Intuitively, it is easy to visualize that after the crack initiation, during the growth stages, some of the load transferred initially by the fastener at the cracked hole will decrease, and it will be shed to the adjacent fasteners that will carry higher loads than in uncracked condition. Using currently available computer software, the method presented in this paper provides a relatively quick and quantitatively defined solution to account for the effects of crack length on the fastener loads transfer, and on the far field and bypass loads at each fastener adjacent to the crack. At each location, these variations are determined from the 3-dimensional distribution of stresses in the joint, and accounting for secondary bending effects and fastener tilt. Two cases of a typical skins lap splice with eight fasteners in a two rows configuration loaded in tension are presented and discussed, one representative for wing or fuselage skins configurations, and the second case representative for cost effective laboratory testing. Each case presents five cracking scenarios, with the cracks growing from approx. 0.03 inch to either the free edge, next hole or both simultaneously.

Fracture and Fatigue Strength Evaluation of Multiple Site Damaged Aircraft Fuselages - Curved Panel Testing and Analysis

Numerical and experimental investigation of a metallic fuselage stiffened panel loaded with a representative fuselage fatigue spectrum

Modified Fourier-Galerkin Solution For Aerospace Skin-Stiffener Panels Subjected To Interface Force And Mixed Boundary Conditions

Development and Evaluation of Methods of Plane Stress Fracture Analysis. Part 3. Application of the Residual Strength Prediction Technique to Complex Aircraft Structure

Nonlinear Fracture Analysis of Delamination Crack Jumps in Laminated Composites

Fatigue-Crack Detection in a Multi-Riveted Strap-Joint Aluminium Aircraft Panel Using Amplitude Characteristics of Diffuse Lamb Wave Field

Failure Analysis of Hat-Stringer-Stiffened Aircraft Composite Panels under Four-Point Bending Loading

Three-Dimensional BEM and FEM Submodelling in a Cracked FML Full Scale Aeronautic Panel

Case Studies of Aircraft Fuselage Cracking

Damage-Accumulation-Induced Crack Propagation and Fatigue Life Analysis of a Porous LY12 Aluminum Alloy Plate

An Experimental and Numerical Study of Repairs on Composite Substrates with Composite and Aluminum Doublers Using Riveted, Bonded, and Hybrid Joints

Prediction of Bending Fatigue Life of Cracked Out-of-Plane Gusset Joint Repaired by CFRP Plates

On Cyclic-Fatigue Crack Growth in Carbon-Fibre-Reinforced Epoxy–Polymer Composites

The Effects of Fatigue Cracks on Fastener Loads during Cyclic Loading and on the Stresses Used for Crack Growth Analysis in Classical Linear Elastic Fracture Mechanics Approaches

A Comprehensive Multi-Modal NDE Data Fusion Approach for Failure Assessment in Aircraft Lap-Joint Mimics

Fatigue Crack Growth Failure and Lifing Analyses for Metallic Aircraft Structures and Components

Numerical Investigation of an Experimental Setup for Thermoplastic Fuselage Panel Testing in Combined Loading

Comparison of structural response and fatigue endurance of aircraft flap-like box structures subjected to acoustic loading

Progressive failure simulation of angled composite beams subject to flexural loading

Fatigue life and damage tolerance of postbuckled composite stiffened structures with indentation damage

Experimental Tests and Numerical Analyses of Fiber Metal Laminate Panels under Shear Load with Bonded Window Frame