Abstract:A furfural residue-derived activated carbon (AC) supported black-TiO2 photocatalyst was successfully prepared by ultrasonic-assisted sol-gel treatment (USG) and solvothermal treatment (ST) combined with microwave-assisted heating (MH). The prepared composites were characterized and evaluated based on the degradation of tetracycline hydrochloride (TC) under ultraviolet (UV) illumination. The average TiO2 nanoparticle size of the as-synthesized catalysts was between 9 and 11 nm. The bandgap of TiO2-USGM was 1.6 eV, much lower than that of other reference catalysts. Organic carbon and AC in the catalyst play positive roles in reducing the band gap (e.g. 1.6∼2.6 eV) and improving visible-light absorption. The oxygen vacancies are responsible for UV–visible absorption. Adding AC into black TiO2 resulted in a lower degree of recombination of photogenerated electrons. Mott-Schottky plots showed that AC-containing TiO2@AC-STM reduced the value of conduction band value from −0.59 eV to −0.24 eV, which is beneficial to photogenerated electrons. Compared with TiO2, the Ti–O–C and Ti–C- in TiO2@AC remarkably improved the adsorption and catalytic efficiency of TC. In a near-neutral pH environment, TiO2@AC-STM and TiO2@AC-USGM exhibited high removal efficiencies (88.0% and 75.7%, respectively) and degradation rates (0.0418 and 0.0302 μmol/g/s, respectively) at a catalyst load of 0.25 g/L. Notably, the catalyst can be effectively used over a wide range of pH (6–9). The solution pH after treatment was close to neutral, which is advantageous for wastewater treatment. The activation energies were found to be approximately 3.47 kJ/mol. The thermodynamic parameters showed that the photodegradation process was non-spontaneous and endothermic. Based on the trapping experiments, O2⋅- was mainly responsible for TC photodegradation over TiO2@AC-STM, followed by h+. The TC degradation pathways and catalyst stability were also investigated. Biomass-derived carbon-supported catalysts have great potential for waste biomass utilization as green, and low-cost catalysts.

Effect of Oxyfluorination of Activated Carbon on the Adsorption of Tetracycline from Aqueous Solutions

Preparation of activated carbons from Iris tectorum employing ferric nitrate as dopant for removal of tetracycline from aqueous solutions

Rapid Removal of Tetracycline (TC) by Ozonation after Extraction TC from Water into Acetic Acid Solution Using Granular Activated Carbon

Rapid Preparation of Activated Carbon Fiber Felt under Microwaves: Pore Structures, Adsorption of Tetracycline in Water, and Mechanism

Removal of tetracycline from the aquatic environment using activated carbon: A comparative study of adsorption performance based on the activator agents

Iron-Loaded Porous Semi-Coke Activated Carbon as a Highly Effective and Recyclable Adsorbent for Tetracycline Removal in Wastewater

Adsorption Characteristics of Carbon Tetrachloride from Aqueous Solution Onto Polyacrylonitrile-Based Activated Carbon Fiber

Tetracycline Removal from Water by Adsorption on Hydrochar and Hydrochar-Derived Activated Carbon: Performance, Mechanism, and Cost Calculation

Effectively removing tetracycline from water by nanoarchitectured carbons derived from CO2: Structure and surface chemistry influence

Evaluation of iron-loaded granular activated carbon used as heterogeneous fenton catalyst for degradation of tetracycline

Decontamination of tetracycline from aqueous solution using activated carbon/Fe 3 O 4 /ZIF-8 nanocomposite adsorbent

TiO2/activated carbon synthesized by microwave-assisted heating for tetracycline photodegradation

Preparation of Activated Carbon-Reinforced Composite Beads Based on MnO2/MCM-41@Fe3O4 and Calcium Alginate for Efficient Removal of Tetracycline in Aqueous Solutions

Adsorption performance and optimization by response surface methodology on tetracycline using Fe-doped ZIF-8-loaded multi-walled carbon nanotubes

Adsorption of Pharmaceuticals to Microporous Activated Carbon Treated with Potassium Hydroxide, Carbon Dioxide, and Steam.

Removal of Tetracycline by Hydrous Ferric Oxide: Adsorption Kinetics, Isotherms, and Mechanism

Modification of Bio-Char Derived from Fast Pyrolysis of Biomass and Its Application in Removal of Tetracycline from Aqueous Solution.

Preparation and characterization of activated carbons from Lemon Pulp for oxytetracycline removal

Opposite impacts of chemical oxidation for ofloxacin adsorption on activated carbon and carbon nanotubes

Efficient Removal of Tetracycline from Water by One-Step Pyrolytic Porous Biochar Derived from Antibiotic Fermentation Residue

A Novel Porous Carbon Derived from Hydrothermal Carbon for Efficient Adsorption of Tetracycline