Abstract:Elevator group control systems (EGCS) have an important effect on the usefulness of buildings, especially for operation of large buildings. The most recent elevator systems have structural differences from the traditional ones, such as Destination Control Systems (DCS), Double-deck elevators, Multi-car elevator system as well as optimization algorithms and modern soft-computing methods. Performance of elevator systems that use DCS is improved given that control strategies can be implemented using the information of destination call before the passenger enters into a car. One of the main issues on controlling elevator groups is related to the measurement of traffic intensity in office buildings. Current studies show that passengers flow is often highest in a heavy incoming traffic situation, such as the traffic observed in the early hours of the morning, also known as the up-peak traffic. In order to deal with this demanding situation, the literature indicates the application of some recent developments, among which, the concepts of division zone technique together with the DCS concept were chosen to be used for the design of the EGCS model described in this paper. Information on call allocation allows special rules to be developed in order to assign an elevator to a sector. This paper proposes a new architecture for an elevator system in commercial office buildings by implementing a control strategy based on fuzzy logic using DCS for a single-car and based on a dynamic-sector approach. The architecture of the elevator group control system was designed to be implemented in a Programmable Logic Controller (PLC) using a DeviceNet® industrial network in order to interconnect industrial instrumentation. The DCS was modeled through human-machine interfaces (HMI) located at each floor.

Development of a distributed elevator control system based on the microcontroller PIC 18F458

MODELING OF AN ELEVATOR GROUP CONTROL SYSTEM USING PROGRAMMABLE LOGIC CONTROL AND DESTINATION CONTROL SYSTEM

Design of Motion Control System Based on EtherCAT

Object-Oriented Modeling of Elevator Control System and Strategies of Elevator Group Control

Automated freight elevator prototype, driven by a frequency inverter, monitored by a supervisory and controlled by a microcontroller

The Design of Display System for Elevator Enclosure Based on STC11L60XE

Design and Analysis of Elevator Control System Using PLC

Group control elevator dispatching system based on S7-1200 PLC

Design of intelligent elevator remote monitoring system based on ethernet

The Software Design of Network-based Elevator Alarm System

An Innovative Lift Control Board Design and Prototype Production Using CANbus Communication System and STM32 Microcontroller

Elevator Control Chip Design

The Five Floor Elevator Control System Design Based on S7-300 PLC

Web-Based Remote Control of a Building’s Electrical Power, Green Power Generation and Environmental System Using a Distributive Microcontroller

Rehabilitation of an Old Traditional Elevator Based on PLC Techniques

Research for Distributed Elevator Group Control Base on Fuzzy Neural Network

The New Dust Removal Controller Based on 80C196 Monochip with PSD Chip

Based on PLC and GM's Two-Speed Elevator Transducer System Design

Web-Based Remote Control of a Building's Electrical Power, Green Power Generation and Environmental System Using a Distributive Microcontroller

Design And Evaluation Of Event-Driven Networked Realtime Control Systems With Iec Function Blocks

PLC-Based Elevator Group Control Simulation System Design