Abstract:An aluminum double-layered electrode (DE-Al) was successfully employed as two electrodes in a symmetrical supercapacitor (double-layered electrode symmetric SC (DE-SC)) and as a positive layer of a triboelectric nanogenerator (DE-TENG) with the aim of energy conversion and storage using a selfsame structured, self-powered flexible device. A facile water-assisted oxidation (WAO) process and metal sputtering after the WAO process can allow the electrodes to greatly improve the active surface area and the conductivity, leading to the enhancement of the electrochemical performances of a supercapacitor (SC). Particularly, this double-layered structure fabrication process is extremely less time-consuming and cost-effective. The electrochemical test of the proposed DE-Al was systematically conducted by cyclic voltammetry (CV), galvanostatic charge-discharge (GCD) and electrochemical impedance spectroscopy (EIS), along with the in-depth characterizations of the surface. From these studies, the DE-Al offers exceptional electrochemical properties compared with other structures, which were utilized as the electrodes in the polyvinyl alcohol/phosphoric acid (PVA/H3PO4) gel electrolyte. The improved performance apparently evidenced from the electrochemical tests of fabricated SC resulted from the enhanced electrical conductivity and large active surface area. The specific capacitance and cycle-life stability of the DE-SC were investigated by using a GCD analysis. Additionally, the EIS curves before and after stability test (for 3500 cycles) were obtained to prove the long-term endurance of DE-SC. A vertical contact and the separation mode of the TENG were also fabricated by using the same DE-Al as a positive layer and polydimethylsiloxane (PDMS) as a negative layer. Finally, the fabricated SC and TENG were successfully combined using a bridge rectifier to convert and store the mechanical energy as electrical energy. This simple design and facile fabrication of a double-layered-electrode-based structure is promising for the development of an energy conversion and storage device.

Realizing high-voltage and ultralong-life supercapacitors by a universal interfacial engineering strategy

Boosting Supercapacitive Performance of Flexible Carbon Via Surface Engineering.

Adapting a Kinetics-Enhanced Carbon Nanostructure to Li/Na Hybrid Water-in-Salt Electrolyte for High-Energy Aqueous Supercapacitors

Enhanced Electrochemical Performance of Supercapacitors via Atomic Layer Deposition of ZnO on the Activated Carbon Electrode Material

A universal strategy to improve interfacial kinetics of solid supercapacitors used in high temperature

Interfacial engineered PANI/carbon nanotube electrode for 1.8 V ultrahigh voltage aqueous supercapacitors

High performance flexible asymmetric supercapacitor constructed by cobalt aluminum layered double hydroxide @ nickel cobalt layered double hydroxide heterostructure grown in-situ on carbon cloth

Modulating electronic and interface structure of CuO/CoNi-LDH via electrochemical activation for high areal-performance supercapacitors

Electrode Surface‐Modified Strategy for Improving the Voltage of Aqueous Supercapacitors

Constructing nickel cobaltate @nickel-manganese layered double hydroxide hybrid composite on carbon cloth for high-performance flexible supercapacitors

Facile Fabrication of Double-Layered Electrodes for a Self-Powered Energy Conversion and Storage System

Highly flexible, foldable carbon cloth/MXene/polyaniline/CoNi layered double hydroxide electrode for high-performance all solid-state supercapacitors

WITHDRAWN: Ingenious design and construction of sandwich-like architecture of CC@NiAl-LDH@GO@NiCo-LDH with high mass loading as electrode material for high performance hybrid quasi-solid-state supercapacitors

Battery-like Supercapacitors from Vertically Aligned Carbon Nanofibers Coated Diamond: Design and Demonstrator

Conductive Modification of Activated Carbon Fiber Cloths via Electrophoretic Deposition for Cathode in Lithium‐Ion Capacitor

Hierarchical graphene oxide/manganese dioxide/cobalt-nickel layered double hydroxide electrodes for high energy density asymmetric flexible supercapacitor

Al doped Ni-Co layered double hydroxides with surface-sulphuration for highly stable flexible supercapacitors

Thin metal film on porous carbon as a medium for electrochemical energy storage

Design of Supercapacitor Electrodes Using Molecular Dynamics Simulations

Significant Role of Al in Ternary Layered Double Hydroxides for Enhancing Electrochemical Performance of Flexible Asymmetric Supercapacitor

Engineering oxygen vacancy-rich CoAl layered double hydroxides coupled with N-doped carbon nanotubes as electrodes for supercapacitors