Bismuth sulfide photocatalysis water treatment under visible irradiation

Atiya Khalid,Naveed Akhtar,Kexin He,Bingxue Liu,Mushtaq Ahmad,Jaweria Ambreen,Safia Hasan,Xiaoming Zhang,Syeda Sitwat Batool,Chuanbo Li
DOI: https://doi.org/10.1007/s11164-021-04471-1
IF: 3.134
2021-04-24
Research on Chemical Intermediates
Abstract:Many contaminants in water are not completely removed by conventional water purification techniques. So, the need of fast and efficient technique for water purification is required for efficient removal. Photocatalysis using low bandgap semiconductors is capable of detoxifying contaminated water. Herein, bismuth sulfide (Bi2S3) nanorods were synthesized using a solid-state reaction method and their photocatalytic performance was tested for the removal of Congo red dye from water. X-ray diffraction (XRD) results confirmed the formation of Bi2S3 with a crystallite size of 5.0 nm. Scanning electron microscopy (SEM) and transmission electron microscopy (TEM) images confirmed the formation of Bi2S3 nanorods with a diameter of 20–30 nm, length of 100 nm -150 nm and an aspect ratio of 5. Photoluminescence (PL) spectrum revealed the bandgap value of 2.47 eV. The specific surface area calculated using Brunauer–Emmett–Teller (BET) of Bi2S3 nanorods was 94.44 m2/g and pore volume was 0.158 cm3/g. The photodegradation of toxic Congo red was performed using Bi2S3 nanorods under UV irradiation. Photodegradation efficiencies up to 87% for Congo red dye were observed within 90 min. The pseudo-first-order (PFO) kinetic model was best fitted to understand the kinetics of photocatalysis. For Bi2S3 nanorods photocatalysts, the apparent rate constant value was 0.01573/min with a 0.997 correlation coefficient value.
chemistry, multidisciplinary
What problem does this paper attempt to address?