Construction of an electrochemical pH sensor using one-pot synthesis of a molybdenum diselenide/nitrogen doped graphene oxide screen-printed electrode
Sujittra Poorahong,Wipawee Oin,Saowaluk Buapoon,Supinya Nijpanich,David J. Harding,Mohamed Siaj
DOI: https://doi.org/10.1039/d4ra01708k
IF: 4.036
2024-05-05
RSC Advances
Abstract:In this study, a one-pot synthesis of a molybdenum diselenide/nitrogen-doped graphene oxide (MoSe 2 /NGO) composite was demonstrated and used for the fabrication of an electrochemical pH sensor. The MoSe 2 /NGO composite was characterized using powder X-ray diffraction, infrared spectroscopy, Raman spectroscopy, X-ray photoelectron spectroscopy, thermogravimetric analysis, scanning electron microscopy, transmission electron microscopy, energy-dispersive X-ray spectroscopy, and Brunauer–Emmett–Teller analysis. The electrochemical behavior at different pH values was determined by recording the open-circuit potential. When applied for pH detection, the MoSe 2 /NGO modified screen-printed electrode (SPE) showed good linearity with a sensitivity of 61.3 mV pH −1 over a wide pH range of 2–14. In addition, the pH sensor exhibited a remarkably stable response, high reproducibility, and selectivity. The sensor was used to measure the acidity or alkalinity of real food and beverage samples. The results for these samples showed a relative error of less than 10% compared with the results obtained with the commercial pH meter. The portable sensor produced by screen printing electrodes paves the way for the development of simple, cost-effective, real-time, and robust pH sensors for the pH analysis of various sample matrices for clinical diagnostics, biosensing, and cost-effective applications.
chemistry, multidisciplinary