Energy absorption and piezoresistive characteristics of 3D printed honeycomb composites with hybrid cell architecture

J Jefferson Andrew,Kamran A. Khan,Rehan Umer,Andreas Schiffer

DOI: https://doi.org/10.1080/17452759.2024.2342430

IF: 10.6

2024-04-20

Virtual and Physical Prototyping

Abstract:This paper introduces a novel hybrid honeycomb (HC) design achieved by continuously blending non-auxetic hexagonal and auxetic re-entrant cell geometries along the out-of-plane direction. These novel hybrid HCs are additively manufactured via fused deposition modelling (FDM) using PA12 polymer reinforced with 15 wt.% of discontinuous carbon fibres. We study the mechanical and piezoresistive performance of hybrid HCs under quasi-static in-plane and out-of-plane loading performed at temperatures ranging between 25-125°C. The results demonstrate significant in-plane compression performance enhancements in the hybrid configuration, achieving up to 43% increase in the collapse strength and 119% in absorbed energy. The incorporation of multiple hybrid layers in the honeycomb structure further enhanced the in-plane properties, ultimately achieving a 181% enhancement in energy absorption. The hybrid honeycombs also showed a pronounced piezoresistive response with gauge factors in the range of 18–37 within the elastic regime, making them suitable for a wide range of multifunctional applications.

engineering, manufacturing,materials science, multidisciplinary

What problem does this paper attempt to address?

The problem that this paper attempts to solve is that in high - performance engineering applications, materials need to possess a specific combination of mechanical properties (such as stiffness, strength, and toughness) while maintaining a low density. However, there are often mutually restrictive relationships among these properties, for example, the balance between stiffness and toughness or the balance between strength and flexibility. To overcome this performance trade - off, researchers proposed a new type of hybrid honeycomb structure (Hybrid Honeycomb, HC), which continuously fuses the hexagonal honeycomb with a non - negative Poisson's ratio and the re - entrant honeycomb geometry with a negative Poisson's ratio to achieve better mechanical properties and piezoresistive characteristics.

Specifically, this research used 3D printing technology (Fused Deposition Modelling, FDM) to manufacture this hybrid honeycomb structure and strengthened it with 15wt.% short carbon fibers of PA12 polymer. The research focused on evaluating the quasi - static in - plane and out - of - plane compressive properties of this hybrid honeycomb structure at different temperatures (25 - 125°C) and its piezoresistive self - sensing behavior. The research results show that this hybrid honeycomb structure has a significant improvement in in - plane compressive properties, with a maximum increase of 43% in collapse strength and 119% in energy absorption capacity. In addition, the multi - layer hybrid honeycomb structure further enhances the in - plane properties, ultimately achieving an 181% increase in energy absorption. The hybrid honeycomb structure also exhibits an obvious piezoresistive response, and the gauge factor in the elastic range is between 18 and 37, which is suitable for a variety of multi - functional applications.