Abstract:In this paper, a high sensitivity method for measurements of Nd isotopes as NdO+, on a TIMS using a single W filament with TaF5 as an ion emitter is presented. Although analyzing Nd isotopes as oxides (NdO+) is a well known technique, this is the first report to analyze Nd isotopic compositions as oxides using W filaments and the TaF5 emitter. When 0.5–1 ng loads of a Neodymium isotopic reference reagent, JNdi-1, were measured using this method, the ion yields were found to be mostly in excess of 15% and could be as high as 32%. Internal precision on 143Nd/144Nd could be better than 10 ppm (2SE) for 1 ng JNdi-1 loads and better than 15 ppm (2SE) for 0.5 ng JNdi-1 loads; thirteen replicates of 0.5–1 ng JNdi-1 loads yielded a 143Nd/144Nd value of 0.512112 ± 0.000028 (2SD). Compared with the previously reported NdO+ measurement method using the Re (or W) filaments + Silica-gel + H3PO4 loading techniques, this method has advantages including higher sensitivity, a more stable ion beam, and no need for oxygen gas to be bled into the ion source chamber. Sm isotopes were analyzed as Sm+ using the W filaments and the TaF5 emitter, and high sensitivity and good ion beam stability were also obtained. Several international rock reference materials, including an ultramafic rock reference material USGS PCC-1 that contains very low amounts of Sm and Nd, were analyzed with full column chemistry and the TaF5 method, and the results of Sm, Nd concentrations and Nd isotopic data are in good agreement with the reported values. Combined with a highly efficient and low-blank column chemistry to separate Nd from Sm, Ce, and Pr, this method holds potential to analyze Sm, Nd concentrations and Nd isotopic compositions of highly depleted peridotites; very small aliquots of minerals such as garnets; extra-terrestrial materials of limited sample size; and environmental samples that contain very low quantities of Sm and Nd.

Rb, Sr, Sm and Nd elemental concentrations and Sr and Nd isotopic ratios of 13 Chinese rock reference materials using isotope dilution TIMS and MC–ICP–MS

Improved in-situ Determination of Sr Isotope Ratio in Silicate Samples Using LA-MC-ICP-MS and Its Wider Application for Fused Rock Powder

Combined chemical separation of Lu, Hf, Rb, Sr, Sm and Nd from a single rock digest and precise and accurate isotope determinations of Lu–Hf, Rb–Sr and Sm–Nd isotope systems using Multi-Collector ICP-MS and TIMS

Determining high-precision Sr-Nd isotopic ratios of certified reference materials using Thermal Ionization Mass Spectrometry

Precise Determination of Sm, Nd Concentrations and Nd Isotopic Compositions at the Nanogram Level in Geological Samples by Thermal Ionization Mass Spectrometry

Characterisation of δ142Ce/140Ce Isotope Ratios in Geological Reference Materials using an SSB+Sm Doping and MC‐ICP‐MS Method

Assessment of Hafnium and Iron Isotope Compositions of Chinese National Igneous Rock Standard Materials GSR-1 (granite), GSR-2 (andesite), and GSR-3 (Basalt)

Development of two novel natural calcite reference materials for enhanced in situ elemental and Sr isotopic analysis.

Mass‐Independent and Mass‐Dependent Ca Isotopic Compositions of Thirteen Geological Reference Materials Measured by Thermal Ionisation Mass Spectrometry

Rapid Separation of Lu-Hf and Sm-Nd from A Single Rock Dissolution and Precise Measurement of Hf-Nd Isotopic Ratios for National Rock Standards

Zinc Isotopic Compositions of NIST SRM 683 and Whole‐Rock Reference Materials

Precise Isotopic Measurements of Sub-Nanogram Nd of Standard Reference Material by Thermal Ionization Mass Spectrometry Using the NdO+ Technique

Ce and Nd stable isotopes purification and determination of geological samples by MC-ICP-MS

Natural Clinopyroxene Reference Materials for in situ Sr Isotopic Analysis via LA-MC-ICP-MS

Separation Method of Rb-Sr, Sm-Nd Using DCTA and HIBA

Silicon Isotope Compositions of Soil and Sediment Reference Materials Determined by MC-ICP-MS

Precise measurements of δ88/86Sr for twenty geological reference materials by double-spike MC-ICP-MS

Potential tourmaline reference materials for microbeam B and Sr isotopic analyses

High‐Precision Measurement of Stable Cr Isotopes in Geological Reference Materials by a Double‐Spike TIMS Method

Determination of Ultra-Trace Platinum, Palladium, Ruthenium, Rhodium, and Iridium in Rocks and Minerals by Inductively Coupled–Plasma Mass Spectrometry Following Nickel Sulfide Fire Assay Preconcentration and Open Mixed Acid Digestion

Silicon Isotope Compositions of Soil and Sediment Reference Materials Determined by MC‐ICP‐MS