Enhanced recovery of phosphorus from hypophosphite-laden wastewater via field-induced electro-Fenton coupled with anodic oxidation

Juanjuan Zhang,Yunhan Liu,Jiaxi Li,Kaifeng Wang,Xu Zhao,Xueyu Liu
DOI: https://doi.org/10.1016/j.jhazmat.2023.132750
IF: 13.6
2024-02-01
Journal of Hazardous Materials
Abstract:Electrochemical recovered ferric phosphate (FePO<sub>4</sub>) precipitates from hypophosphite-laden wastewater were shown to be an efficient method for phosphorus (P) recovery. However, the influence of chloride ions (Cl<sup>-</sup>) coexisting commonly in wastewater is not known for this treatment. Herein, a field-induced electro-Fenton coupled with anodic oxidation electrochemical system consisting of a Ti-RuO<sub>2</sub> anode, an Fe inductive electrode and an activated carbon fiber (ACF) cathode, namely Ti-RuO<sub>2</sub>/Fe/ACF(NaCl) system, was established to recover phosphorus (P) as FePO<sub>4</sub> from hypophosphite-laden wastewater in the presence of Cl<sup>-</sup>. This system enabled a hypophosphite (H<sub>2</sub>PO<sub>2</sub><sup>-</sup>, 1.0 mM) removal ratio of ~100% and all P was recovered within 30 min at 5.0 V under the initial solution pH of 3.0. The Faradaic efficiency and energy consumption of P recovery achieved the maximum value (~94%) and the lowest value (~16 kW h kg<sup>-1</sup> P), respectively. Reactive oxygen species including <sup>1</sup>O<sub>2</sub>, Fe<sup>IV</sup>O<sup>2+</sup>, •O<sub>2</sub><sup>-</sup> and •OH contribute to convert H<sub>2</sub>PO<sub>2</sub><sup>-</sup> to PO<sub>4</sub><sup>3-</sup>, which immediately formed FePO<sub>4</sub> with the generated Fe<sup>3+</sup> at the optimized conditions. Therein, the contribution of non-radical <sup>1</sup>O<sub>2</sub> was very considerable. This system exhibited good stability. The efficiency and cost for treatment of actual hypophosphite-laden wastewater were addressed to check its applicability for P recovery.
environmental sciences,engineering, environmental
What problem does this paper attempt to address?