Abstract:Laboratory measurements of capillary pressure (Pc) and the electrical resistivity index (RI) of reservoir rocks are used to calibrate well logging tools and to determine reservoir fluid distribution. Significant studies on the methods and factors affecting these measurements in rocks containing oil, gas, and water are adequately reported in the literature. However, with the advent of chemical enhanced oil recovery (EOR) methods, surfactants are mixed with injection fluids to generate foam to enhance the gas injection process. Foam is a complex and non-Newtonian fluid whose behavior in porous media is different from conventional reservoir fluids. As a result, the effect of foam on Pc and the reliability of using known rock models such as the Archie equation to fit experimental resistivity data in rocks containing foam are yet to be ascertained. In this study, we investigated the effect of foam on the behavior of both Pc and RI curves in sandstone and carbonate rocks using both porous plate and two-pole resistivity methods at ambient temperature. Our results consistently showed that for a given water saturation (Sw), the RI of a rock increases in the presence of foam than without foam. We found that, below a critical Sw, the resistivity of a rock containing foam continues to rise rapidly. We argue, based on knowledge of foam behavior in porous media, that this critical Sw represents the regime where the foam texture begins to become finer, and it is dependent on the properties of the rock and the foam. Nonetheless, the Archie model fits the experimental data of the rocks but with resulting saturation exponents that are higher than conventional gas-water rock systems. The degree of variation in the saturation exponents between the two fluid systems also depends on the rock and fluid properties. A theory is presented to explain this phenomenon. We also found that foam affects the saturation exponent in a similar way as oil-wet rocks in the sense that they decrease the cross-sectional area of water available in the pores for current flow. Foam appears to have competing and opposite effects caused by the presence of clay, micropores, and conducting minerals, which tend to lower the saturation exponent at low Sw. Finally, the Pc curve is consistently lower in foam than without foam for the same Sw.

Review of foam stability in porous media: The effect of coarsening

Microfluidic Investigation of Foam Coarsening Dynamics in Porous Media at High-Pressure and High-Temperature Conditions

Experimental and modeling study of foam coarsening kinetics in porous media

Pore-level mechanics of foam generation and coalescence in the presence of oil

Limiting coarsening of a two-bubble foam with viscosity

Effects of liquid fraction and contact angle on structure and coarsening in two-dimensional foams

Bubble-Population-Balance Modeling for Supercritical Carbon Dioxide Foam Enhanced-Oil-Recovery Processes: From Pore-Scale to Core-Scale and Field-Scale Events

Foam coarsening in a yield stress fluid

Static evolution and flow characteristics of foam in fractures

Hierarchical bubble size distributions in coarsening wet liquid foams

Bubble Coarsening Kinetics in Porous Media

Effects of Pore Geometry on Flowing Foam Dynamics in 3D-Printed Porous Media

Quantitative Characterization of Foam Transient Structure in Porous Media and Analysis of Its Flow Behavior Based on Fractal Theory

Status of Foam as a Liquid Blocking Agent in Porous Media: A Review

Coarsening and mechanics in the bubble model for wet foams

A Pore-Level Study of Dense-Phase CO2 Foam Stability in the Presence of Oil

The Peak Viscosity of Decaying Foam with Natural Drainage and Coarsening

Bubble-particle dynamics in multiphase flow of capillary foams in a porous micromodel

Effects of Foam Microbubbles on Electrical Resistivity and Capillary Pressure of Partially Saturated Porous Media

Foam Flow in Heterogeneous Porous Media: Effect of Cross Flow

3D simulations of wet foam coarsening evidence a self similar growth regime