Abstract:In the context of Concentrated Solar Power (CSP) technology, this paper presents a comparison between the Parabolic Trough Collector (PTC) and the Linear Fresnel Collector (LFC), considering both evacuated and non-evacuated receiver tubes. The comparison was carried out in terms of the Levelized Cost of Electricity (LCOE) considering a reference year and four locations in the world, characterized by different levels of direct normal irradiation (DNI) from 2183 kWh/m2/year to 3409 kWh/m2/year. The LCOE depends on economic parameters and on the net energy generated by a plant on an annual basis. The latter was determined by a steady-state 1D model that solved the energy balance along the receiver axis. This model required computing the incident solar power and heat losses. While the solar power was calculated by an optical ray-tracing model, heat losses were computed by a lumped-parameter model developed along the radial direction of the tube. Since the LFC adopted a secondary concentrator, no conventional correlation was applicable for the convective heat transfer from the glass cover to the environment. Therefore, a 2D steady-state CFD model was also developed to investigate this phenomenon. The results showed that the PTC could generate a higher net annual energy compared to the LFC due to a better optical performance ensured by the parabolic solar collector. Nevertheless, the difference between the PTC and the LFC was lower in the non-evacuated tubes because of lower heat losses from the LFC receiver tube. The economic analysis revealed that the PTC with the evacuated tube also achieved the lowest LCOE, since the higher cost with respect to both the LFC system and the non-evacuated PTC was compensated by the higher net energy yield. However, the non-evacuated LFC demonstrated a slightly lower LCOE compared to the non-evacuated PTC since the lower capital cost of the non-evacuated LFC outweighed its lower net annual energy yield. Finally, a sensitivity analysis was conducted to assess the impact on the LCOE of the annual optical efficiency and of the economic parameters. This study introduces key technical parameters in LFC technology requiring improvement to achieve the level of productivity of the PTC from a techno-economic viewpoint, and consequently, to fill the gap between the two technologies.

Technical and economic study of solar energy concentration technologies (linear Fresnel and parabolic trough collectors) to generate process heat at medium temperature for the dairy industry of Spain

Energy and economic evaluation of a middle-sized CSP parabolic field in an agro-industrial company

Techno-Economic Evaluation of Future Thermionic Generators for Small-Scale Concentrated Solar Power Systems

Experimental Investigation of a Small-Scale Parabolic Trough Concentrated Solar Power ‎Systems

Fuzzy Logic Energy Management Strategy of a Multiple Latent Heat Thermal Storage in a Small-Scale Concentrated Solar Power Plant

Techno-economic Analysis of Hybrid Solar Thermal Systems with Flat Plate and Parabolic Trough Collectors in Industrial Applications

Low-Pressure Steam Generation with Concentrating Solar Energy and Different Heat Upgrade Technologies: Potential in the European Industry

Turbo-assisted direct solar air heater for medium temperature industrial processes using Linear Fresnel Collectors. Assessment on daily and yearly basis

Continuous Solar Thermal Energy Production Based on Critical Irradiance Levels for Industrial Applications

Comparative Techno-Economic Analysis of Parabolic Trough and Linear Fresnel Collectors with Evacuated and Non-Evacuated Receiver Tubes in Different Geographical Regions

Energy saving in industrial buildings using advanced concentrated solar thermal systems

Toward a sustainable dairy industry in Mexico: optimization of a parabolic trough solar collector system with passive heat-transfer enhancement techniques and a machine learning approach

Optical Performance Analysis of a Hybrid Parabolic Trough Collector with Photovoltaic Slats.

Thermal energy demand decarbonization for the industrial sector via an innovative solar combined technology

Thermoeconomic Analysis of a Solar-Assisted Industrial Process Heating System

Integrate of night radiative cooling technology using a photovoltaic thermal collector under three different climates

Pre-Feasibility Assessment Tool for Solar Industrial Process Heating

Technical and economic assessment of hybrid PVT solar systems compared to independent solar thermal and photovoltaic collectors in high-temperature zones: A case study in Mexicali, Mexico

Proposal and Study of a Pumped Thermal Energy Storage to Improve the Economic Results of a Concentrated Solar Power That Works with a Hybrid Rankine–Brayton Propane Cycle

Techno-economic analysis of solar PV power-to-heat-to-power storage and trigeneration in the residential sector

Technical, economic and environmental analysis of solar thermochemical production of drop-in fuels