Abstract:The nonlinearity of sinusoidal doubly salient electro-magnetic machine (SDSEM) leads to the fuzzy optimization range of its design parameters. And there is a conflict problem in multiple optimization objectives. Therefore, the multi-objective optimization of SDSEM with two different excitation modes is carried out based on the Gray-Fuzzy-Taguchi method. Firstly, the proposed sinusoidal method of square wave back electromotive force (EMF) phase modulation is introduced. And the key parameters to improve the symmetry and sinusoidal degree of the back EMF waveform are pointed out. Then, the sensitivity of key parameters is analyzed and the signal-to-noise (S/N) ratio is calculated by Taguchi orthogonal test. Secondly, the S/N ratio is linearly normalized by grey correlation analysis. Then, fuzzy reasoning is used to synthesize multiple performance indexes of the motor into a multiple performance characteristics index (MPCI) value, and the optimal scheme is obtained. Finally, the optimized SDSEM with concentrated magneto-motive forces (SDSEM-CF) and SDSEM with distributed magneto-motive forces (SDSEM-DF) are simulated and compared. The SDSEM-DF prototype is developed and verified by experiments. The results show that the no-load back EMF of the prototype has a good sinusoidal degree. Based on vector control, the sinusoidal drive of DSEM is realized without increasing the control complexity, which greatly reduces the torque ripple of the flux reluctance motor.

A Sinusoidal Doubly Salient Electromagnetic Machine Drive Fed by Third-Harmonic Injection Two-Stage Matrix Converter with Integrated Injection Inductor

FEA-Based Mathematical Modeling and Simulation for IPMSM Drive with Consideration of Saturation and Cross-Coupling Influence

Hybrid Frame-Based Current Control Scheme for LC-Equipped PMSM with Non-Sinusoidal Back-EMF

Current Control Scheme for LC-Equipped PMSM Drive Considering Decoupling and Resonance Suppression in Synchronous Complex-Vector Frame

A Novel DC-Excited Doubly Salient Machine with Modular II-Shaped Stator Iron Core

Harmonic Currents Injection Strategy with Optimal Air Gap Flux Distribution for Multiphase Induction Machine

Six-phase induction machine driven by the matrix converter

Control of A Stand-Alone Wind Energy Conversion System Via A Third-Harmonic Injection Indirect Matrix Converter

A Single Sided Matrix Converter Drive for a Brushless DC Motor in Aerospace Applications.

A Novel Third Harmonic Current Injection Method to Optimize the Air-gap Flux for Multiphase Induction Machine

A New Phase Current Reconstruction Scheme For Four-Phase Srm Drives Using Improved Converter Topology Without Voltage Penalty

Hybrid Modulation Strategy for Two-Stage Matrix Converter and its Application in Vector Control of Doubly Fed Induction Generator.

Air-gap and Yoke Flux Density Optimization for Multiphase Induction Motor Based on Novel Harmonic Current Injection Method

High-Density Planar Integrated Magnetics with Two-Sided Merged Inductor Windings and Integrated Cores for Resonant DC/DC Converter

Sensorless Control for Five-phase Induction Motors With Improved Third-harmonic Current Injection

The Optimized Triloop Control Strategy of Integrated Motor-Drive and Battery-Charging System Based on the Split-Field-Winding Doubly Salient Electromagnetic Machine in Driving Mode

Analysis and multi-objective optimization design of sinusoidal DSEM with two different excitation modes based on Gray-Fuzzy-Taguchi method

A Simple Modulation Scheme With Zero Common-Mode Voltage and Improved Efficiency for Direct Matrix Converter-Fed PMSM Drives

Precise Control of Flat-Topped Air-Gap Magnetic Field in a Five-Phase Induction Machine Powered by Third-Harmonic-Injected Sinusoidal Supply

Position-Sensorless Control of $\text{dc} + \text{ac}$ Stator Fed Doubly Salient Electromagnetic Motor Covered Full Speed Range

Improved Third-Harmonic Injection Two-Stage Matrix Converter Topology Based on Decomposition Control of Injection Current