Abstract:The treatment of nanoparticle (NP) polluted aqueous suspensions by flotation can be problematic due to the low probability of collision between particles and bubbles. To overcome this limitation, the present work focuses on developing an enhanced flotation technique using the surface-functionalized micro-bubbles - colloidal gas aphrons (CGAs). The CGA generator was adapted to be air flow rate controlled based on the classical Sebba system; thus it could be well adopted in a continuous flotation process. Cetyl trimethylammonium bromide (CTAB) and sodium dodecyl sulfate (SDS) were employed for CGA creation. Positively surface-charged CTAB-CGAs (similar to 44.1 mu m in size) and negatively surface-charged SDS-CGAs (similar to 42.1 mu m in size) were produced at the optimum stirring speed of 8000 rpm. The half-life of CGAs varied from 100 s to 340 s under the tested conditions, which was largely sufficient for transferring CGAs from bubble generator to flotation cell. The air flow led to less stable CTAB-CGAs but apparently enhanced the stability of SDS-CGAs at higher air flow rates. In the presence of air flow, the drainage behavior was not much related to the type of surfactants. The continuous CGA-flotation trials highlighted the effective separation of silica nanoparticles - the removal efficiencies of different types of SiO2 NPs could reach approximately 90%-99%; however, at equivalent surfactant concentrations, no greater than 58% of NPs were removed when surfactants and bubbles were separately added into the flotation cell. The SiO2 NPs with small size were removed more efficiently by the CGA-flotation process. For the flotation with CTAB-CGAs, the neutral and basic initial SNP suspension was recommended, whereas the SDS-CGAs remained high flotation efficiency over all investigated pH. The good performance of CGA-flotation might be interpreted: most of the surfactant molecules well covered/coated on the surfaces of stable CGAs and thus fully contacted with NPs, resulting in the efficient utilization of surfactants. (C) 2017 Elsevier Ltd. All rights reserved.

Multi-walled carbon nanotubes as collector for the removal of cationic red X-GRL from wastewater by foam fractionation: shortcoming and remedy

Boosting the Adsorption and Removal of Dye from Water by COOH-functionalized Carbon Nanotubes

Surface-modified Microbubbles (colloidal Gas Aphrons) for Nanoparticle Removal in a Continuous Bubble Generation-Flotation Separation System.

Removal of micron-scale microplastic particles from different waters with efficient tool of surface-functionalized microbubbles

High Flux MWCNTs-interlinked GO Hybrid Membranes Survived in Cross-Flow Filtration for the Treatment of Strontium-Containing Wastewater.

Removal of Nanoplastics from Aqueous Solution by Aggregation Using Reusable Magnetic Biochar Modified with Cetyltrimethylammonium Bromide

Catalytic Ceramic Nanofiber Membrane Coupled with Ozonation for Degradation of Sulfamethoxazole: Critical Parameters, Mechanisms and Applicability

Use of magnetic nanoparticle loaded functionalized multi-walled carbon nanotubes for effective removal of Maxilon red GRL from aqueous solutions

Robust and Highly Efficient Free‐Standing Carbonaceous Nanofiber Membranes for Water Purification

Effective sorptive removal of five cationic dyes from aqueous solutions by using magnetic multi-walled carbon nanotubes

Removal of anionic and cationic dyes from wastewater by adsorption using multiwall carbon nanotubes

Removal of 6-methylquinoline from shale gas wastewater using electrochemical carbon nanotubes filter

The all-or-none role of innervation in expression of apamin receptor and of apamin-sensitive Ca2+-activated K+ channel in mammalian skeletal muscle.

Autoantibodies to the insulin receptor as a cause of autoimmune hypoglycemia in systemic lupus erythematosus.

Anti-Swelling 2d Clay Nanofiltration with Interlamellar Fixation for Efficient Dye Separation

Selective molecular separation with conductive MXene/CNT nanofiltration membranes under electrochemical assistance

Surfactant removal with multiwalled carbon nanotubes

Modification of regenerated cellulose ultrafiltration membranes with multi-walled carbon nanotubes for enhanced antifouling ability: Field test and mechanism study

Schiff base crosslinked graphene/oxidized nanofibrillated cellulose/chitosan foam: An efficient strategy for selective removal of anionic dyes

Enhanced Dye Adsorption on Cold Plasma-Oxidized Multi-Walled Carbon Nanotubes: A Comparative Study

A New Solid Phase Extractor Based on Cross-linked PMMA@CNTs/GNP for the Removal of Crystal Violet and Methylene Blue Dyes