Abstract:This paper presents bench studies on the treatment of saline oil-in-water emulsions (synthetic and real produced water) by a novel flocculation technique combining sodium dodecylbenzene sulfonate and a high molecular weight cationic polyacrylamide, followed by floc separation by gravity and/or with microbubbles (dissolved air flotation - DAF). The effects of temperature, reagents concentration, medium pH, salinity (sodium chloride concentration), and water hardness on the separation efficiency were investigated. The best results for total oil and grease (TOG) removal were around 90% and residual TOG content between 7 and 13 mg L -1 in the treated water. These results were obtained with 20-40 mg L -1 of sodium dodecylbenzene sulfonate followed by 7 mg L -1 of polyacrylamide, at 25 oC and at pH between 6-7. The microbubbles were generated by hydrodynamic cavitation in a needle valve after dissolving air in water at a saturation pressure of 4 bar with a 20% recycling ratio. The mechanisms involved were discussed in terms of interfacial phenomena occurring at the oil/water interface with the formation of polymer-surfactant complexes (PSCs). Notably, this instantaneous aggregation process occurs without the need for slow mixing, as in conventional flocculation. The flocculation of the emulsified oil droplets appears to involve, simultaneously, the formation of a polymer-surfactant complex, whereby the hydrophobic forces play an important role, and interactions between the oil droplets (coated with sodium dodecylbenzene sulfonate and the polyacrylamide). Here, large and light (cluster-like) hydrophobic flocs, with enmeshed/entrained oil (de-emulsified), immediately rise (as a phase separation) towards the water/air interface due to the low density, together with the small flocs rising with the microbubbles. Due to the high process efficiency and the high quality of the treated water, this flocculation technique appears to have a very good potential for oil-bearing wastewater treatment at a high rate, especially in refineries and offshore platforms of crude oil extraction.

Oil filaments produced by an impeller in a water stirred thank

A fountain of droplets

Investigation of the Film Formation Mechanism of Oil-in-water (O/W) Emulsions

Dispersion of silicone oil in water surfactant solution: Effect of impeller speed, oil viscosity and addition point on drop size distribution

Surfactant-assisted spreading of an oil-in-water emulsion on the surface of a liquid bath

Study of oil droplet patterns and laws of motion based on multi-field synergistic effects

Experimental Characterization and Evaluation of Crude Spiking Influence on Oil/Water Dispersed Flow in Pipe

One-pot Mussel-Inspiration and Silication: A Platform for Constructing Oil-Repellent Surfaces Toward Crude Oil/water Separation

Detergency and its implications for oil emulsion sieving and separation

Tubulation and dispersion of oil by bacterial growth on droplets

Flocculation of emulsified oil-in-water with dodecylbenzene sulfonate and polyacrylamide and floc separation by dissolved air flotation

Separation of silicone oil droplets dispersed in activated sludge

Experimental investigation of an oil droplet colliding with an oil-water interface

Lifetime of oil drops pressed by buoyancy against a planar interface: Large drops

Experimental investigation of laminar and turbulent displacement of residual oil film

Modulating outcomes of oil drops bursting at a water-air interface

Oil-Water Two-Phase Flow with Three Different Crude Oils: Flow Structure, Droplet Size and Viscosity

Microbubbles enhance oil-in-water emulsion separation in fibrous coalescers

Development of foam-like emulsion phases in porous media flow

Membrane emulsification using membranes of regular pore spacing: Droplet size and uniformity in the presence of surface shear

Visualizing in-situ emulsification in porous media during surfactant flooding: A microfluidic study