Abstract:An electrocatalytic nitrogen reduction reaction is considered a potential approach for green ammonia production─a zero-carbon fertilizer, fuel, and energy storage for renewable energy. To harness the synergistic properties of perovskites, the inherent dipole moment due to their non-centrosymmetric structure (that facilitates better charge separation), oxygen vacancies, and the presence of Ni metal sites that permit activation and reduction of N2 efficiently, the NiTiO3-based nanoelectrocatalysts have been synthesized. Further, these catalysts have been modified with ultra-small metal nanocrystal co-catalysts to form heterointerfaces that not only aid to improve the charge separation but also activate N2 and lower overpotential requirements. The appearance of peaks corresponding to (012), (104), (110), (11-3), (024), (11-6), (018), (027), and (300) confirms the formation of rhombohedral NiTiO3. The shift in the XRD peak corresponding to the (104) plane to a smaller 2θ value and peak shifting and widening of Raman spectra imply the lattice distortion that signifies the formation of Pd-NiTiO3 and Pt-NiTiO3 heterojunction electrocatalysts with the loadings of 0.4 and 0.3 wt % of Pd and Pt, respectively, as confirmed by ICP-OES analysis. The detailed XPS analysis reveals the presence of Pd (0), Pd (II), and Pt (0), Pt (II) in respective electrocatalysts. The appearance of XPS peaks at 528.7 and 531.1 eV suggests the presence of oxidative oxygen species (O2-/O-) and the presence of oxygen defects due to oxygen vacancy. The detailed nitrogen reduction (NRR) investigation exhibits a 5-fold enhancement in ammonia yield rate (∼14.28 μg h-1 mg-1 at -0.003 V vs RHE), a faradic efficiency of 27% (at 0.097 V vs RHE) for Pd-NiTiO3 electrocatalysts than that for bare NiTiO3 (3.08 μg h-1 mg-1), and 9-folds higher than that of the activity shown by the commercial TiO2 (P25) (1.52 μg h-1mg-1). The formation of ammonia was further confirmed by using isotopic nitrogen as the feeding gas. Furthermore, the highest NRR is observed at lower cathodic potential (-0.003 V vs RHE) in the case of the Pd-NiTiO3 electrocatalyst than that of the Pt-NiTiO3 electrocatalyst (-0.203 V vs RHE), implying significantly reduced overpotential requirement. Such enhanced NRR activity with lower overpotential requirement in the case of the Pd-NiTiO3 electrocatalyst is due to efficient charge separation as shown by the semicircle Nyquist plot, decreased photoluminescence emission intensity, shorter average lifetime (∼29 ns) of excitons, appropriate band bending, and improved activation of N2 by the oxygen vacancies and heterointerface formed between Pd nanocrystals and NiTiO3. Furthermore, no change is observed in the current density, after stabilization in the initial few seconds, even up to 2 h, which signifies that these electrocatalysts are stable. The structural and morphological integrity of the optimized catalyst remained even after the nitrogen reduction reactions, as revealed by no significant change observed in FESEM, elemental mapping, and EDS analysis.

Electrochemical dinitrogen to ammonia reduction at a nickel(II) site: an easy access to an air-stable catalyst

Theory-Guided Construction of the Unsaturated V-N<sub>2</sub> Site with Carbon Defects for Highly Selective Electrocatalytic Nitrogen Reduction

Regulating Intermediate Adsorption and H2O Dissociation on a Diatomic Catalyst to Promote Electrocatalytic Nitrate Reduction to Ammonia

Au Sub-Nanoclusters on TiO 2 toward Highly Efficient and Selective Electrocatalyst for N 2 Conversion to NH 3 at Ambient Conditions.

N‐Coordinated Cu–Ni Dual‐Single‐Atom Catalyst for Highly Selective Electrocatalytic Reduction of Nitrate to Ammonia

Nitrogen-coordinated Single Fe Sites for Efficient Electrocatalytic N2 Fixation in Neutral Media

Elaborately tuning the electronic structure of single-atom nickel sites using nickel nanoparticles to markedly enhance the electrochemical reduction of nitrate into ammonia

Electrochemical reduction of nitrate to ammonia via direct eight-electron transfer using a copper–molecular solid catalyst

Selective Electrochemical Conversion of N2 to NH3 in Neutral Media Using B, N-Containing Carbon with a Nanotubular Morphology

Homogeneous, Heterogeneous and Biological Catalysts for Electrochemical N2 Reduction towards NH3 under Ambient Conditions

Electrochemical Ammonia Synthesis via Nitrogen Reduction Reaction on a MoS 2 Catalyst: Theoretical and Experimental Studies

Highly Selective Electrochemical Reduction Of Dinitrogen To Ammonia At Ambient Temperature And Pressure Over Iron Oxide Catalysts

(Invited) Electrochemical Nitrogen Fixation under Ambient Conditions

Homogeneous, Heterogeneous, and Biological Catalysts for Electrochemical N2 Reduction Toward NH3 under Ambient Conditions

Nickel-based dual single atom electrocatalysts for the nitrate reduction reaction

Atomically Dispersed Molybdenum Catalysts for Efficient Ambient Nitrogen Fixation

Role of Electronic Structure on Nitrate Reduction to Ammonium: A Periodic Journey.

A Rare-Earth Samarium Oxide Catalyst for Electrocatalytic Nitrogen Reduction to Ammonia

Enhanced Nitrogen Reduction to Ammonia by Surface- and Defect-Engineered Co-catalyst-Modified Perovskite Catalysts under Ambient Conditions and Their Charge Carrier Dynamics

Molecular single iron site catalysts for electrochemical nitrogen fixation under ambient conditions