Investigation effect of Lu-substitution on structural, morphological, magnetic, and dielectric properties of BaM hexaferrite synthesized using a co-precipitation method

Jiajun Han,Huangyi Wang
DOI: https://doi.org/10.1016/j.mtcomm.2024.108148
IF: 3.8
2024-02-02
Materials Today Communications
Abstract:In this paper, we synthesized Lu-substituted M-type barium ferrites (BaLu x Fe 12- x O 19 , x = 0, 0.2, 0.4, 0.6, 0.8) by chemical co-precipitation using a non-stoichiometric ratio of raw materials. We investigated their structure, XPS, and EDX spectra, morphology, and magnetic and dielectric properties. The XRD patterns showed that the diffraction peaks shifted toward a lower angle and the lattice constant ratio ( c/a ) was less than 3.98, which was within the allowable range of magneto-plumbite structure. XPS and EDX spectra confirmed the presence of O, Fe, Ba, and Lu elements in the samples. SEM images revealed that the ceramic samples sintered at 1330 °C had a regular and obvious hexagonal structure. Lu substitution promoted grain growth, with an average grain size increase of 163% and a maximum grain size of 21.77 μm. Hysteresis loops indicated the formation of a multi-domain structure in the samples. The coercivity decreased from 2035.82 Oe to 574.84 Oe and the saturation magnetization decreased as well but still exceeded 58 emu/g. The dielectric constants of all the samples were in the order of 10 3 to 10 4 and the substitution of Lu significantly increased it to about 16k. The tangent loss could be maintained below 0.5, with a minimum of approximately 0.1. The Lu-substitution barium ferrites with high saturation magnetization, low coercivity, high dielectric constant, and low tangent loss coexistence may be a potential candidate for application in low-frequency wireless communication with miniaturization and multifunction.
materials science, multidisciplinary
What problem does this paper attempt to address?