Abstract:Direct membrane filtration (DMF) has gained a lot of attention in recent years because of its potential to treat low-strength and low temperature wastewater, where biological based treatments are inefficient. However, fouling is a major concern which keeps this technique from being more widely used. The main aim of this study was to investigate membrane fouling, its mitigation approaches and the organic/nutrient retention during DMF of municipal wastewater by adjusting operational parameters and pretreating the sewage. In a laboratory-scale setup employing crossflow to mitigate fouling, both ultrafiltration and microfiltration membranes were utilized. Physicochemical pre-treatment of sewage with polyaluminum chloride and polyamide significantly inhibited membrane fouling and improved organics/nutrient retention. Subsequent experiments with physiochemically pre-treated sewage, using microfiltration and ultrafiltration separately, revealed that (i) an increase in crossflow velocity from 1 to 2 m s −1 improved filtration performance by reducing irreversible fouling, (ii) elevating transmembrane pressure from 0.18 to 0.4 bar increased both reversible and irreversible fouling, and (iii) periodic relaxation increased the extent of irreversible fouling, contributing to higher overall fouling in ultrafiltration. When employing DMF for sewage concentration, ultrafiltration demonstrated superior filtration performance and organics retention compared to microfiltration. Furthermore, through pre-precipitation and microsieving (100 μm) followed by DMF with ultrafiltration membranes, a remarkable removal efficiency of 92 % for chemical oxygen demand (COD), 98 % for total phosphorus (TP), and 100 % for total suspended solids (TSS) was achieved. By cleaning the fouled membranes using an alkaline cleaning solution (Ultrasil-10) at 50 °C, combined with a crossflow of 1 m s −1 , the permeability was completely restored. Overall, this study demonstrates that by optimizing operational settings and cleaning conditions, a sustainable DMF process for wastewater treatment with controlled membrane fouling and improved resource recovery can potentially be developed for upscaling. Short abstract This study investigated the effectiveness of direct membrane filtration for municipal wastewater treatment. It was found that physicochemical pre-treatment with polyaluminum chloride and polyamide significantly reduced membrane fouling and improved nutrient retention. Ultrafiltration membranes demonstrated superior performance and nutrient retention compared to microfiltration membranes. By optimizing operational parameters and cleaning conditions, a sustainable direct membrane filtration process with controlled fouling and improved resource recovery can be developed for wastewater treatment.

Direct membrane filtration (DMF) of municipal wastewater by mixed matrix membranes (MMMs) filled with graphene oxide (GO): Towards a circular sanitation model

Azido-group Functionalized Graphene Oxide/polysulfone Mixed Matrix Ultrafiltration Membrane with Enhanced Interfacial Compatibility for Efficient Water and Wastewater Treatment

Guanidyl-functionalized Graphene/polysulfone Mixed Matrix Ultrafiltration Membrane with Superior Permselective, Antifouling and Antibacterial Properties for Water Treatment

Membranes fouling propensity of PSF/GO hollow fiber mixed matrix membranes for water treatment ultrafiltration application

A mussel-induced approach to secondary functional cross-linking 3-aminopropytriethoxysilane to modify the graphene oxide membrane for wastewater purification

Direct Membrane Filtration (DMF) of municipal wastewater – A study on the prevention and remediation of fouling

Direct membrane filtration of municipal wastewater: Assessment of different fouling control strategies to enhance its energy, environmental and economic viability

Next-generation Graphene Oxide Additives Composite Membranes for Emerging Organic Micropollutants Removal: Separation, Adsorption and Degradation.

Development of an efficient, low-operating-pressure graphene oxide/polyethersulfone nanofiltration membrane for removing various water contaminants

Development of advanced nanocomposite membranes using graphene nanoribbons and nanosheets for water treatment

Synthesis of composite membranes modified with graphene oxide and polyethylene glycol for the removal of emerging contaminants from water

Metal-organic framework-intercalated graphene oxide nanofiltration membranes for enhanced treatment of wastewater effluents

Enhanced filtration membranes with graphene oxide and tannic acid for textile industry wastewater dye removal

Simultaneous anti-fouling and flux-enhanced membrane distillation via incorporating graphene oxide on PTFE membrane for coking wastewater treatment

Modification of Cellulose Acetate Microfiltration Membranes Using Graphene Oxide–Polyethyleneimine for Enhanced Dye Rejection

Graphene oxide modified membrane for highly efficient wastewater treatment by dynamic combination of nanofiltration and catalysis

A high flux graphene oxide nanoparticles embedded in PAN nanofiber microfiltration membrane for water treatment applications with improved anti-fouling performance

Surface Microstructure Drives Biofilm Formation and Biofouling of Graphene Oxide Membranes in Practical Water Treatment

Self-assembled membrane with excellent antifouling performance for enhanced treatment of petrochemical wastewater

Multifunctional PVDF/CNT/GO Mixed Matrix Membranes for Ultrafiltration and Fouling Detection

Graphene Oxide-Polysulfone Hollow Fibers Membranes with Synergic Ultrafiltration and Adsorption for Enhanced Drinking Water Treatment