Abstract:The increasing need for sharing workspace and interactive physical tasks between robots and humans has raised concerns regarding safety of such operations. In this regard, controllable clutches have shown great potential for addressing important safety concerns at the hardware level by separating the high-impedance actuator from the end effector by providing the power transfer from electromagnetic source to the human. However, the existing clutches suffer from high power consumption and large-weight, which make them undesirable from the design point of view. In this paper, for the first time, the design and development of a novel, lightweight, and low-power torque-adjustable rotary clutch using electroadhesive materials is presented. The performance of three different pairs of clutch plates is investigated in the context of the smoothness and quality of output torque. The performance degradation issue due to the polarization of the insulator is addressed through the utilization of an alternating current waveform activation signal. Moreover, the effect of the activation frequency on the output torque and power consumption of the clutch is investigated. Finally, a time-dependent model for the output torque of the clutch is presented, and the performance of the clutch was evaluated through experiments, including physical human-robot interaction. The proposed clutch offers a torque to power consumption ratio that is six times better than commercial magnetic particle clutches. The proposed clutch presents great potential for developing safe, lightweight, and low-power physical human-robot interaction systems, such as exoskeletons and robotic walkers.

Improving Speed Characteristics of High-Torque-Density Motors for Physical Human–robot Interaction Using an Independent Three-Phase Winding Structure

Design and Torque Optimization of Single-phase Hybrid Switched Reluctance Motors

Beyond End-Effector: Utilizing High-Resolution Tactile Signals for Physical Human–Robot Interaction

Design and Analysis of High Torque-to-weight Ratio Motors for Legged Robot Joints

Air-gap and Yoke Flux Density Optimization for Multiphase Induction Motor Based on Novel Harmonic Current Injection Method

Design of an Actuator for Biped Robots Based on the Axial Flux Motor.

Design of a High-torque Robot Joint and Its Control System

The Dynamic Effect of Gearbox Parameters for Physical Human-robot Interaction Performance

Design and Modeling of a Smart Torque-Adjustable Rotary Electroadhesive Clutch for Application in Human-Robot Interaction

The High-payload Manipulator Development Based on Novel Two-stage Cycloidal Speed Reducers and Hub Motors

Motion Control of a Direct Drive Permanent-Magnet Motor Selective Compliant Articulated Robot for Assembly

A Novel 2-DOF Planar Parallel Robot with High Accelerate / High Precision

Research on a Novel Transverse Flux Permanent Magnet Motor With Hybrid Stator Core and Disk-Type Rotor for Industrial Robot Applications

Control Approach for a Novel High Power-To-Weight Ratio Actuator Scalable in Force and Length for Robots

Research of 2-DOF Planar Parallel High Speed/high Accuracy Robot

Structure Optimization for Brushless DC Motor in Robot's Arms Using FEM

An Energy-Efficient Torque Controller Based On Passive Dynamics Of Human Locomotion For A Robotic Transtibial Prosthesis

Static Characteristic Analysis and Force Optimization of A Short-Stroke Planar Motor

Advanced 2-DOF Counterbalance Mechanism based on Gear Units and Springs to Minimize Required Torques of Robot Arm

Sensorless Interaction Force Control Based on B-Spline Function for Human-Robot Systems

Research of a Novel 2-DOF Planar Parallel Robot System