Abstract:This study presents the characterization and source apportionment of water-soluble inorganic ions (WSII), contained in particulate matter with an aerodynamic diameter equal to or less than 2.5 μm (PM2.5), performed using the positive matrix factorization model (PMF). PM2.5 were collected in Mexico City from two sites: at Merced (MER), which is a residential location with commercial activities, and at Metropolitan Autonomous University (UAM), which is located in an industrial area. The monitoring campaign was carried out across three seasons named Hot Dry (HD) (March–June), Rain (RA) (July–October), and Cold Dry (CD) (November-February). PM2.5 concentration behavior in both sites was similar, following the order: CD > HD > RA. The UAM site exhibited higher concentrations of PM2.5, of the five cations (Na+, Mg2+, Ca2+, K+ and NH4+), and of the four anions (Cl−, SO42−, NO3− and PO43−) than MER, since the UAM site is surrounded by several industrial zones. PM2.5 average concentrations for UAM and MER were 28.4 ± 11.2 and 20.7 ± 8.4 μg m−3, respectively. The ratio of cation equivalent to anion equivalent (CE/AC) showed that aerosol pH is acidic, which was confirmed by direct pH measurements. The sulfur oxidation rate (SOR) was 20 times larger than the nitrogen oxidation rate (NOR). Additionally, SO42− was the most abundant ion during the whole year, especially during the CD season with 5.13 ± 2.5 μg m−3 and 4.9 ± 3.6 μg m−3 for UAM and MER, respectively, when solar radiation displayed a high intensity. On the opposite side, the conversion of NO2 to NO3−, respectively, was low. The air mass backward trajectories were modeled using the National Oceanic and Atmospheric Administration (NOAA-HYSPLIT), which allowed us to know that differences in the mass trajectories during the days with higher concentrations were due to an effect of air recirculation, which favored PM2.5 accumulation and resuspension. On the other hand, on the days with less PM2.5, good air dispersion was observed. The main sources identified with the PMF model were secondary aerosol, vehicular, industrial crustal, and biomass burning for UAM, while for MER they were vehicular, secondary aerosol, and crustal.

Chemical Characterization and Assessment of Public Health Risk due to Inhalation of PM2.5 in the City of Salamanca, Guanajuato

Seasonal Characteristics of the Chemical Composition of Fine Particles in Residences of Nanjing, China.

Sampling, composition, and biological effects of Mexico City airborne particulate matter from multiple periods

Hazardous trace elements in thoracic fraction of airborne particulate matter: Assessment of temporal variations, sources, and health risks in a megacity

Risk Estimation of Heavy Metals Associated with PM2.5 in the Urban Area of Cuernavaca, México

An Economic Analysis of the Environmental Impact of PM2.5 Exposure on Health Status in Three Northwestern Mexican Cities

Spatiotemporal Characteristics and Health Risk Assessment of Heavy Metals in PM2.5 in Zhejiang Province

Characterization of airborne particles and cytotoxicity to a human lung cancer cell line in Guangzhou, China

Elemental composition and health risk assessment of PM10, PM2.5, at different microenvironments: Addis Ababa, Ethiopia

Airborne particulate matter integral assessment in Magdalena department, Colombia: Patterns, health impact, and policy management

PM2.5 Characterization and Source Apportionment Using Positive Matrix Factorization at San Luis Potosi City, Mexico, during the Years 2017–2018

Monitoring human genotoxicity risk associated to urban and industrial Buenos Aires air pollution exposure

Characteristics of Mass Concentration, Chemical Composition, Source Apportionment of PM2.5 and PM10 and Health Risk Assessment in the Emerging Megacity in China

Bioaccessibility and Health Risk of Arsenic and Heavy Metals (cd, Co, Cr, Cu, Ni, Pb, Zn and Mn) in TSP and PM2.5 in Nanjing, China

Chemical composition, mutagenicity, and cytotoxicity of urban submicron particulate matter (PM1) in Agra, India

Chemical Speciation and Health Risk Assessment of Fine Particulate Bound Trace Metals Emitted from Ota Industrial Estate, Nigeria

Concentrations of Ni and V, other heavy metals, arsenic, elemental and organic carbon in atmospheric fine particles (PM2.5) from Puerto Rico

Temporal Variation and Potential Sources of Water-Soluble Inorganic Ions in PM2.5 in Two Sites of Mexico City

Effects of PM10 Airborne Particles from Different Regions of a Megacity on In Vitro Secretion of Cytokines by a Monocyte Line during Different Seasons

Characterization, Source Apportionment and Health Risk Assessment of PM2.5 for a Rural Classroom in the Amazon: A Case Study

Risk assessment of PM(2.5) to child residents in Brazilian Amazon region with biofuel production