Abstract:<p>Zwitterions have been attracting great attention for researchers to tailor the separation membranes featuring enhanced water permeability and excellent antifouling property. Here we functionalized polyamide membrane surface with small-molecule zwitterions through sequential interfacial polymerization (SIP) technique to improve the performance of RO membranes. Zwitterionic molecules 3-(4-(2-((4-aminophenyl)amino)ethyl)morpholino-4-ium)propane-1-sulfonate (PPD-MEPS) and amino acid Arginine were covalently bonded onto the PA surface via the amine groups of two zwitterions. Consequently, the surface hydrophilicity of both modified membranes were significantly improved with WCA decreased from ∼60° to ∼28°, and their surface negative charge also decreased to some extent at high pH values. The water permeability increased from 2.45 LMH/bar to 3.81–3.85 LMH/bar, increasing by about 57%, while maintained a NaCl rejection as high as 98.5%. In addition, the zwitterions-modified RO membranes exhibited much improved antibacterial attachment (E.coil) and fouling resistance to model foulants bovine serum albumin (BSA), lysozyme (LYZ) and humic acid (HA). Therefore, the facile zwitterions modified membranes possessing high water permeability and excellent antifouling performance, especially using amino acid Arg may find their potential promising application in water treatment.</p>
What problem does this paper attempt to address?
This paper attempts to prepare high - performance reverse osmosis (RO) membranes by surface - grafting small - molecule zwitterions to solve the problems of low water permeability and serious membrane fouling in the existing reverse osmosis membranes during water treatment processes. Specifically, the authors used two small - molecule zwitterions - synthesized 3-(4-(2-((4 - aminophenyl)amino)ethyl)morpholin - 4 - ium)propane - 1 - sulfonate (PPD - MEPS) and natural amino acid arginine (Arg), and grafted them onto the surface of polyamide membranes through sequential interfacial polymerization (SIP) technology to improve the performance of the membranes.
### Main Objectives:
1. **Increase water flux**: By introducing zwitterions, enhance the hydrophilicity of the membrane surface, thereby increasing the water permeability.
2. **Enhance anti - fouling performance**: Zwitterions can effectively reduce the attachment of bacteria and other pollutants on the membrane surface and improve the anti - fouling ability of the membrane.
3. **Maintain high salt rejection rate**: While increasing the water flux, maintain a relatively high salt rejection rate to ensure the efficiency of water treatment.
### Methods:
- **Materials and Chemicals**: A variety of chemical reagents were used, such as PSf ultrafiltration membranes, 1,3,5 - benzenetricarbonyl chloride (TMC), bovine serum albumin (BSA), lysozyme (LYZ), humic acid (HA), etc.
- **Membrane Preparation**: Through sequential interfacial polymerization (SIP) technology, the original polyamide RO membranes were first prepared, and then modified with PPD - MEPS and Arg respectively.
- **Membrane Characterization**: X - ray photoelectron spectroscopy (XPS), attenuated total reflection Fourier transform infrared spectroscopy (ATR - FTIR), scanning electron microscopy (SEM), atomic force microscopy (AFM) and other techniques were used to characterize the surface chemical composition, morphology and roughness of the membranes.
- **Performance Evaluation**: The water flux and salt rejection rate of the membranes were tested through cross - flow modules, and their anti - fouling performance and bacterial attachment performance were evaluated.
### Results:
- **Surface Hydrophilicity**: The water contact angle on the surface of the modified membranes decreased significantly, from about 60° to about 28°, indicating that the hydrophilicity of the membrane surface was significantly enhanced.
- **Water Flux**: The water flux of the modified membranes increased from 2.45 LMH/bar to 3.81 - 3.85 LMH/bar, an increase of about 57%.
- **Salt Rejection Rate**: The NaCl rejection rate of the modified membranes remained at about 98.5%.
- **Anti - Fouling Performance**: The anti - fouling performance of the modified membranes against BSA, LYZ, HA and Escherichia coli (E. coli) was significantly improved.
- **Surface Charge**: The negative surface charge of the modified membranes decreased at high pH values, which helps to reduce the electrostatic adsorption with pollutants with opposite charges.
### Conclusions:
By the method of surface - grafting small - molecule zwitterions, high - performance reverse osmosis membranes were successfully prepared. These membranes have higher water flux, stronger anti - fouling ability and good salt rejection rate, and are expected to be widely used in the water treatment industry.