Abstract:Experience from many years of measurements in urban areas in Sweden shows that high concentrations of various air pollutant components occur not only in large cities but also in small towns. One possible reason is variation in the local meteorological conditions causing poor ventilation facilities. For some years IVL has used an empirical statistical calculation method (the so called "URBAN-model") developed by IVL. The model has primarily been used for estimating the risk of exceeding different national standard values of air pollution concentrations in small and medium sized towns in Sweden. The purpose of this investigation was to develop a method in a test area to improve the calculations of air pollution concentrations used in the former URBAN-model. This was achieved by reproducing the local meteorological variations better in a new ventilation index and a dispersion-adjusting constant and also with better temporal and spatial resolution of the parameters. By using an advanced numerical model, TAPM (The Air Pollution Model), the old ventilation factor was improved by using the output parameters mixing height and wind-speed respectively, for calculating new ventilation parameters with high time and spatial resolution (1 month and 1x1 km). The results were then included in an improved calculation routine/model implemented into the URBAN model. Since the TAPM model previously has only been validated in Asia and as the circumstances are rather different in northern Europe (rain, soil moisture day length etc) it was necessary to verify the models performance on meteorology modelling, before using the output of the model to develop new ventilation parameters. The validation showed that the model performs well in simulating air temperature and wind, which are the two most important fields to drive air pollution modelling. Also, TAPM was confirmed to have strong ability in simulating thermally driven mesoscale systems, such as sea-land breeze and urban heat island effects. It is thus concluded that TAPM is a very useful tool for local meteorological air pollution applications. A comparison between monthly averages of measured and calculated NO2 concentrations (with the new model) shows a fair accordance. When comparing NO2 calculated with the old and the new URBAN-model and NO2 measurements, the new model shows a much better agreement with measured data. Consequently, the need of evaluation of the air quality in communities and small cities can be better met by using this improved URBAN model. Since the time consuming and complicated meteorological modelling is only used to generate the new ventilation parameters, the actual NO2 calculations with the new URBAN model can still remain rather simple compare to other dispersion models. The method developed for the test area can be developed for whole Sweden and thus meets the extended demands of accurate air pollution calculations in small communities.

On relationships between urban and rural near-surface meteorology for diffusion applications

On the Applicability of Ground-Based Microwave Radiometers for Urban Boundary Layer Research

Atmospheric Dispersion Simulation in Low Wind Conditions in Inland Hills and Valleys

Development of a New Meteorological Ventilation Index for Urban Air Quality Studies

Numerical Simulation of Atmospheric Boundary-layer Structure over Urban and Rural Areas

Construction and Validation of an Urban Area Flow and Dispersion Model on Building Scales

Urban-Scale Computational Fluid Dynamics Simulations with Boundary Conditions from Similarity Theory and a Mesoscale Model

Application of Turbulent Diffusion Term of Aerosols in Mesoscale Model

On the application and grid-size sensitivity of the urban dispersion model CAIRDIO v2.0 under real city weather conditions

A CFD-BASED AIR QUALITY DISPERSION MODELING FOR URBAN AREAS USING OPENFOAM

Development and applications of a fine urban boundary layer model

Effects of Urban Underlying Surface Change on Ambient Atmospheric Environment

Validation and applications of an urban diffusion model for vehicular pollutants

Mathematical Modeling of the Diffusion of Impurities in the Atmosphere for a Local Domain Considering Actual and Forecasting Fields of Meteorological Parameters

A numerical study on atmospheric transport and diffusion response to rapid urbanization

A Study of Evolution and Dynamics of Urban Atmospheric Mixing-Layer Depth Based on Lidar Data and Numerical Simulation

Delimitation of Urban Hot Spots and Rural Cold Air Formation Areas for Nocturnal Ventilation Studies Using Urban Climate Simulations

A New Approach for Understanding Urban Microclimate by Integrating Complementary Predictors at Different Scales in Regression and Machine Learning Models

Urban Meteorology, Pollutants, Geomorphology, Fractality, and Anomalous Diffusion

Assessment of Puff-Dispersion Variability Through Lagrangian and Eulerian Modelling Based on the JU2003 Campaign

A multi-scale urban atmospheric dispersion model for emergency management