High output power density and strong vibration durability in a modified barbell-shaped energy harvester based on multilayer Pb(In 1/2 Nb 1/2 )O 3 –Pb(Mg 1/3 Nb 2/3 )O 3 –PbTiO 3 single crystals

Jinfeng Liu,Xiangyu Gao,Chaorui Qiu,Liao Qiao,Jingya Yang,Ming Ma,Kexin Song,Haisheng Guo,Zhuo Xu,Fei Li

DOI: https://doi.org/10.1063/5.0035474

IF: 6.6351

2021-01-01

APL Materials

Abstract:Traditional piezoelectric energy harvesters are made of piezoelectric ceramics with a cantilever structure, which show a low output energy density. Thus, they are difficult to meet the requirements for self-powered electronics. Herein, we report a modified barbell-shaped piezoelectric energy harvester (BSPEH) based on two <i>d</i>₃₃-mode cuboid Pb(In_1/2Nb_1/2)O₃–Pb(Mg_1/3Nb_2/3)O₃–PbTiO₃ multilayer single crystal stacks (ten wafers with a thickness of 0.5 mm and <i>d</i>₃₃ ∼ 1300 pC/N). Due to the electrically parallel and series connections of multilayer piezoelectric elements and the high figure-of-merit <i>d</i>₃₃ × <i>g</i>₃₃ of the single crystal, the maximum power density of BSPEH could reach 39.7 mW cm⁻³ (under an acceleration of 5 g), which is much higher than that of traditional cantilever piezoelectric energy harvesters (CPEHs), ∼0.1 mW cm⁻³. A maximum output voltage of 50.4 <i>V</i>_p–p was obtained when two crystal stacks are connected in series, and a maximum output current of 880 <i>µ</i>A can be obtained when two crystal stacks are connected in parallel. Furthermore, the energy harvesting properties of BSPEH stay almost the same after 10⁶ vibration cycles, while the properties of CPEH decrease 20% after 10⁵ vibration cycles. This work indicates that BSPEH has a great potential in the application of wireless sensor networks for realizing the self-power of the equipment.

materials science, multidisciplinary,physics, applied,nanoscience & nanotechnology