Pyrene‐Based "Turn‐on" Fluorescent Polymeric Probe with Thioacetal Units in The Main Chain for Mercury(II) Detection in Aqueous Solutions And Living Cells

Yu Gu,Siyong Li,Yue Yu,Jianjian Zhu,Xingyu Yuan,Xinxin Feng,Yanbing Lu
DOI: https://doi.org/10.1002/marc.202300631
IF: 5.006
2023-12-31
Macromolecular Rapid Communications
Abstract:A water‐soluble polymeric PTA‐Py with thioacetal units in the main chain was simply synthesized by direct polycondensation of 3, 6‐dioxa‐1, 8‐octanedithiol, 1‐pyrene formaldehyde and mPEG2k‐SH. The probe PTA‐Py showed a good fluorescence response to Hg2+ ions due to the Hg2+‐promoted deprotection reaction of thioacetal groups to regenerate the original 1‐pyrene formaldehyde compound. After adding Hg2+ to the PTA‐Py solution, the fluorescence intensity (FI) gradually increased with increasing concentrations of Hg2+. Compared with other metal ions, the probe exhibited high sensitivity, good selectivity and rapid response to Hg2+. The low detection limits were 12.3 nM in ethanol‐PBS buffer and 13.3 nM in water, respectively. The results implied that the simply synthesized water‐soluble polymeric probe had potential applications in the rapid detection of Hg2+ ions in aqueous solutions. Moreover, the polymeric PTA‐Py showed high sensitivity for CH3Hg+ with detection limits of 26.5 nM in ethanol/PBS buffer. In addition, PTA‐Py can efficiently detect Hg2+ ions in HeLa cells. The results demonstrated that a valuable method was developed for biocompatible polymeric sensors for Hg2+ ions in biological and environmental samples. This article is protected by copyright. All rights reserved
polymer science
What problem does this paper attempt to address?