Abstract:Ni2Fe‐LDH/FeNi2S4/NF is prepared by a partial sulfidation of Ni2Fe‐LDH/NF. Abundant hydroxide/sulfide interfaces boost the alkaline water oxidation. Impressively, cyclic voltammetry activation results in the formation of a sulfate layer that largely enhances the corrosion resistance of the catalyst in the alkaline salty‐water electrolytes. The development of a high‐performance electrocatalyst for oxygen evolution reaction (OER) is imperative but challenging. Here, a partial sulfidation route to construct Ni2Fe‐LDH/FeNi2S4 heterostructure on nickel foam (Ni2Fe‐LDH/FeNi2S4/NF) by adjusting the hydrothermal duration is reported. The heterostructures afford abundant hydroxide/sulfide interfaces that offer plentiful active sites, rapid charge and mass transfer, favorable adsorption energy to oxygenated species (OH− and OOH) evidenced by the density functional theory calculations, which synergistically boost the alkaline water oxidation. In the 1.0 m KOH solution, Ni2Fe‐LDH/FeNi2S4/NF exhibits an excellent OER catalytic activity with a much smaller overpotential (240 mV) to reach the current density of 100 mA cm−2 than single‐phase Ni2Fe‐LDH/NF (279 mV) or FeNi2S4/NF (271 mV). More impressively, 2000 cycles of cyclic voltammetry scan for water oxidation results in the formation of a sulfate layer over the catalyst. The corresponding post‐catalyst demonstrates better OER activity and durability than the initial one in the alkaline simulated seawater electrolyte. The post‐Ni2Fe‐LDH/FeNi2S4/NF delivers smaller overpotential (250 mV) at 100 mA cm−2 and longer stability time than the original form (260 mV). The post‐formed sulfate passivating layer is responsible for the outstanding corrosion resistance of the salty‐water oxidation anode since it can effectively repel chloride.

Partial Selenization Strategy for Fabrication of Ni0.85Se@NiCr‐LDH Heterostructure as an Efficient Bifunctional Electrocatalyst for Overall Water Splitting

Hierarchical NiCo2S4@NiFe LDH Heterostructures Supported on Nickel Foam for Enhanced Overall-Water-Splitting Activity

Synergistic modulation of NiSe2 by doping with chromium and nitrogen for high-efficiency overall water splitting

Ni0.85Se As an Efficient Non-Noble Bifunctional Electrocatalyst for Full Water Splitting

Nickel-iron Selenide Polyhedral Nanocrystal with Optimized Surface Morphology As a High-Performance Bifunctional Electrocatalyst for Overall Water Splitting

A three-dimensional nickel-chromium layered double hydroxide micro/nanosheet array as an efficient and stable bifunctional electrocatalyst for overall water splitting

Ferrum-doped nickel selenide @tri-nickel diselenide heterostructure electrocatalysts with efficient and stable water splitting for hydrogen and oxygen production

Partial sulfidation strategy to NiCo-LDH@NiCoS coupled with NiFe-LDH for highly efficient overall water splitting

A highly efficient and robust hybrid structure of CoNiN@NiFe LDH for overall water splitting by accelerating hydrogen evolution kinetics on NiFe LDH

Partial Sulfidation Strategy to NiFe‐LDH@FeNi2S4 Heterostructure Enable High‐Performance Water/Seawater Oxidation

Interface engineering of heterogeneous NiMn layered double hydroxide/vertically aligned NiCo 2 S 4 nanosheet as highly efficient hybrid electrocatalyst for overall seawater splitting

OH-enriched NiS/Ni3S2-Zr Heterostructure for Overall Water Splitting Performance in Alkaline Media

Boosting Charge Transfer Via Interface Charge Reconstruction Between Amorphous NiFe-LDH and Crystalline NiCo2O4 for Efficient Alkaline Water/seawater Oxidation

Synthesis of NiSe 2 @M (M=Cu, Fe and Zn)–NiCo LDH with porous structure on nickel foam for overall fresh and seawater splitting

Boosting charge transfer via interface charge reconstruction between amorphous NiFe-LDH and crystalline NiCo 2 O 4 for efficient alkaline water/seawater oxidation

Modulating the Surface Electronic Structure of Active Ni Sites by Engineering Hierarchical NiFe-LDH/CuS over Cu Foam as an Efficient Electrocatalyst for Water Splitting

Amorphous Ni-Fe-Se hollow nanospheres electrodeposited on nickel foam as a highly active and bifunctional catalyst for alkaline water splitting.

Self-supported Ni3Se2@NiFe layered double hydroxide bifunctional electrocatalyst for overall water splitting

Self-Supported Nickel Iron Layered Double Hydroxide-Nickel Selenide Electrocatalyst for Superior Water Splitting Activity

Self‐Supported Sand Rose‐Like MoSe2/NiSe/NiFe‐LDH Bifunctional Electrocatalyst for Overall Water Electrolysis

NiFe-LDH coated NiSe/Ni foam as a bifunctional electrocatalyst for overall water splitting