Abstract:Two fluorescent high‐performance polymers based on dicyanoarylamine luminogens were readily synthesized via polycondensation. Both polymers were soluble in several polar aprotic solvents and exhibited useful levels of thermal stability. The polymers were emissive in both solution and solid film states, thereby demonstrating the aggregation‐induced fluorescence changes. Introduction Fluorescent high‐performance polymers have been extensively used in designing optoelectronic devices due to their low cost, excellent thermal stability, high mechanical strength, low flammability, good chemical and radiation resistance, and good electronic properties. While conventional organic luminophores fluoresce strongly in dilute solutions, they suffer from undesirable aggregation‐caused quenching in concentrated solutions and in the solid state due to extensive π‐π stacking interactions and formation of delocalized excitons or excimers. This phenomenon leads to non‐radiative decay thus, decreased fluorescence emission of the material in the solid film state, which significantly limits their real‐world application as solid light‐emitting materials. Objectives To develop new high‐performance polymers with high photo luminescent efficiency, good processability, film‐forming properties, which could potentially be used in the fabrication of optoelectronic devices. Methods The preparation of the polyimide DiCN‐PI was carried out by a one‐step, high‐temperature solution imidization method. In this procedure, 1,2,4,5‐cyclohexanetetracarboxylic dianhydride and the diamine were polymerized in 1‐methyl‐2‐pyrrolidinone and γ‐butyrolactone co‐solvent at 180°C for 15 hours in the presence of isoquinoline as catalyst. On the other hand, polyamide DiCN‐PA was synthesized according to the direct phosphorylation polycondensation technique described by Yamazaki from diamine and trans‐1,4‐cyclohexanedicarboxylic acid using triphenyl phosphite and pyridine as condensing agents. Results and Discussion Both polymers were soluble in several polar aprotic solvents and exhibited useful levels of thermal stability. The polymers were emissive with PL emission bands around 555 (bluish‐green) and 498 (cyan) nm in dilute 1‐methyl‐2‐pyrrolidinone solutions for polyimide and polyamide, respectively. In the solid film state, the polymers emit light green and yellow colors, which simulate the PL behavior of their aggregated states, thereby demonstrating aggregation‐induced fluorescence changes. Conclusions These results indicate that the incorporation of bulky dicyanoarylamine moiety and alicyclic monomer units into the rigid polymer backbones effectively disrupted the planarity of the chain packing which resulted to the fluorescent high‐performance polymers with desired properties for potential optoelectronic applications.

Synthesis, photophysical, electrochemical and thermal investigation of Triarylamines based on 9H-Xanthen-9-one: Yellow–green fluorescent materials

Synthesis and Light-Emitting Properties of Disubstituted Polyacetylenes Carrying Chromophoric Naphthylethynylphenyl Pendants

Novel Meso-Polyarylamine-bodipy Hybrids: Synthesis and Study of Their Optical Properties

The synthesis and photophysical properties of novel triphenylamine derivatives containing α, β-diarylacrylonitrile

The synthesis and photoluminescence characteristics of novel α,β-diarylacrylonitrile derivatives containing both a biphenyl group and a triphenylamine unit

Synthesis and fluorescence property modulation of α-cyano-1,4-diphenylbutadiene derivatives containing triphenylamine structure

Aggregation-induced Emission of Triphenylamine Substituted Cyanostyrene Derivatives

Synthesis and luminescence-tuning of naphthalimidetriphenylamine dyad

Luminescence Properties Of Aminobenzanthrones And Their Application As Host Emitters In Organic Light-Emitting Devices

Synthesis, characterization, and photophysical properties of dicyanoarylamine‐based semi‐aromatic polymers

Research Pregress on Synthesis of Xanthene Dyes

Synthesis, Structural Characterization, Spectroscopic Properties, and Theoretical Investigations of Aminoacridine Derivatives

Synthesis and Electrochromic Properties of Epoxy Materials Containing Triphenylamine Units

Phenyl-Bridged N,N,N'N'-Tetrasubstituted Bis(2-Amino-5-Thiazolyl) Diamine: Synthesis and Applications in Electrochromism and Photocatalytic Nitrobenzene Reduction

Fluorescence switching of triarylamine-based polyamides with pendant pyrene units and its application in electrochromic smart displays

Investigations and Facile Synthesis of a Series of Novel Multi-Functional Two-Photon Absorption Materials

Synthesis and Electrochromic Properties of Novel Poly(urethane–azomethine)s Containing Triphenylamine Units

Synthesis, Crystal Structure and Photoluminescent Properties of Novel 9-Cyano-Pyrrolo[1,2-a][1,10]Phenanthrolines

Concept of triphenylamine side chains with four electroactive nitrogen centers toward record-high stable electrochromic polyamides

Novel triphenylamine polyamides bearing carbazole and aniline substituents for multi-colored electrochromic applications

Supramolecular aggregation properties of naphthalimide-decorated imino-Naphthol and imino-naphthalene based on fluorescent materials