Abstract:For energy efficient ventilation and low carbon design, solar chimney has been extensively applied on buildings. In the present work, three representative solar chimneys were introduced, i.e., Model 1 with top-horizontal outlet, Model 2 with upper-vertical outlet and Model 3 with middle-vertical outlet. Updraft ventilation from the built enclosure to the outlet and heat transfer from the absorber to the fluid by heat convection were numerically and theoretically investigated, and their limitations and correlations with governing parameters were also discussed. Streamlines and heatlines were used to visualize transport paths of air and heat respectively. Reverse flow could not be observed in the solar chimney channels of Model 2 and Model 3; Therefore, total volume flow rate induced by the solar chimneys Model 2 and Model 3 and convection heat transfer rate of the absorber increases positively with thermal Rayleigh numbers ( Ra ). Model 2 chimney produces greater thermal buoyancy than that by Model 3, and its air flow rate is higher than that of Model 3. Generally, volume flow rate induced in Model 1 is higher than those of Model 2 and Model 3 as Ra is no more than 2.5 × 10 6 , and simultaneously, convection heat transfer rate Nusselt number ( Nu ) is also greater than those of Model 2 and Model 3. When Ra exceeded 2.5 × 10 6 , reverse air flow was intensified further, Nu of Model 1 started to decline. The three models with discrete heat sources could induce more air from indoor than that respective model without discrete heat sources. The maximum increment rate is obtained by the Model 1 solar chimney with discrete heat sources, then Model 2 and the least done by Model 3. Their power relationships between Nu and Ra , V*and Ra are regressed respectively. The dependence of volume flow rate on broad thermal Rayleigh numbers covering all the three flow regimes showed that there were linear correlations between discrete numerical volume flow rates and the scaling predictions, except in Model 1 for high Ra (exceeding critical value 9.0 × 10 5 ), where volume flow rate was remarkably reduced due to reverse air flow. This research could provide useful theoretical information for applying small sized vertical solar chimneys attached to the building sidewall to effectively reduce built energy consumption.

On the form of the power equation for modeling solar chimney power plant systems

Construction Analysis of the Chimney of Solar Thermal Power Station

Numerical Simulation of Wind Load on Solar Thermal Power Station with 100 MW Output

Numerical Modeling and Analysis of Nuclear Power, Solar Photovoltaic Power and Wind Power

Study of the Turbulence Model Effect on the Airflow Characteristics Inside a Solar Chimney Power Plant

Mathematical model of concentrating solar cooker

Mathematical model of a solar module for energy yield simulation in photovoltaic systems

A New Analytical Model for Airflow in Solar Chimneys Based on Thermal Boundary Layers

Investigating the Influence of Absorber Plate Geometry on Solar Chimney Performance

Development of a Model for Performance Analysis of a Honeycomb Thermal Energy Storage for Solar Power Microturbine Applications

Wind-Induced Response of the Solar Chimney

Impact of the chimney junction radius on the airflow characteristics inside a solar Chimney Power Plant

Numerical investigation on performance of a solar chimney power plant with different absorber configurations

Evaluation of Three Analytical Solar Chimney Models with Field Data

Thermal and energy analysis of a novel solar updraft tower design with divergent chimney and convergent collector concept: CFD analysis with experimental validation

Structural and Heat Transfer Model Analysis of Wall-Mounted Solar Chimney Inlets and Outlets in Single-Story Buildings

Heat removal and ventilation limitations of the solar chimney attached with a built enclosure: Correlations of thermal Rayleigh numbers, port arrangements and discrete heating elements

An Efficient 3D Tube-Level Flux-Thermal Model of External Tubular Receivers in Solar Power Tower Systems

Theoretical analysis and numerical study of natural convection inside combined solar chimney

Structure Optimization and Cost Analysis of 10 MW Solar Chimney Power Generation System

Numerical analysis of the divergent solar chimney power plant with a novel arc and fillet radius at the chimney base region